enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Marine grade stainless - Wikipedia

   en.wikipedia.org/wiki/Marine_grade_stainless

   SAE 316 stainless steel is a molybdenum-alloyed steel and the second most common austenitic stainless steel (after grade 304). It is the preferred steel for use in marine environments because of its greater resistance to pitting corrosion than most other grades of steel without molybdenum. [ 1 ]

3. SAE 316L stainless steel - Wikipedia

   en.wikipedia.org/wiki/SAE_316L_stainless_steel

   SAE 316L grade stainless steel, sometimes referred to as A4 stainless steel or marine grade stainless steel, is the second most common austenitic stainless steel after 304/A2 stainless steel. Its primary alloying constituents after iron , are chromium (between 16–18%), nickel (10–12%) and molybdenum (2–3%), up to 2% manganese , [ 1 ] with ...

4. ISO 2852 - Wikipedia

   en.wikipedia.org/wiki/ISO_2852

   ISO 2852 Stainless steel clamp pipe couplings for the food industry [1] was an international standard that defines a non-permanent sanitary food-grade piping interconnect method, commonly used in the food processing industry and with dairy farm equipment. The interconnect consists of:

5. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   [21]: 149 Instead, pipe and fittings with plain (non-belled) connections are butted against each other, and clamped with special rubber sleeve (or "no-hub") fittings. [18]: 71 The rubber sleeves are typically secured with stainless steel worm drive clamping bands, which compress the rubber to make a tight seal around the pipes and fittings.

6. JIC fitting - Wikipedia

   en.wikipedia.org/wiki/JIC_fitting

   JIC fittings, defined by the SAE J514 and MIL-DTL-18866 standards, are a type of flare fitting machined with a 37-degree flare seating surface. JIC (Joint Industry Council) fittings are widely used in fuel delivery and fluid power applications, especially where high pressure (up to 10,000 pounds per square inch (690 bar)) is involved.

7. Hose coupling - Wikipedia

   en.wikipedia.org/wiki/Hose_coupling

   It is usually made of steel, brass, stainless steel, aluminium or plastic. Due to the great variety of the designs and the number of countries in which they were created, it is difficult to trace the origin of many. Patents that cover designs similar to those below include: 1876: Hose-coupling, No. 175,232. [1] Coupling for hose and pipe. US ...