Search results
Results from the WOW.Com Content Network
The debugging interface of Eclipse with a program suspended at a breakpoint. Panels with stack trace (upper left) and watched variables (upper right) can be seen. In software development, a breakpoint is an intentional stopping or pausing place in a program, put in place for debugging purposes. It is also sometimes simply referred to as a pause
The debug control register is used to selectively enable the four address breakpoint conditions, and to specify the type and size of each of the four breakpoints. There are two levels of enabling: the local (0,2,4,6) and global (1,3,5,7) levels.
This led to the development of proprietary software from several independent vendors that provided similar features but deliberately restricted breakpoints and instruction stepping to particular application programs in particular address spaces and threads. The program state (as applicable to the chosen application/thread) was saved for ...
Turbo Debugger (TD) is a machine-level debugger for DOS executables, intended mainly for debugging Borland Turbo Pascal, and later Turbo C programs, sold by Borland.It is a full-screen debugger displaying both Turbo Pascal or Turbo C source and corresponding assembly-language instructions, with powerful capabilities for setting breakpoints, watching the execution of instructions, monitoring ...
Breakpoints... Programs halt when a specified event, a breakpoint, has occurred. The event can be specified as a code execution address, or as a data access (read or write) to an address with a specified value. Nexus breakpoints can be set at any address, including flash or ROM memory; CPUs may also provide special breakpoint instructions.
The same mode is also used by KGDB for debugging a running Linux kernel on the source level with gdb. With KGDB, kernel developers can debug a kernel in much the same way as they debug application programs. It makes it possible to place breakpoints in kernel code, step through the code, and observe variables.
Winpdb debugging itself. A debugger is a computer program used to test and debug other programs (the "target" programs). Common features of debuggers include the ability to run or halt the target program using breakpoints, step through code line by line, and display or modify the contents of memory, CPU registers, and stack frames.
A breakpoint immediately after a Document.Write is ignored. Entering a Document.Write command while debugging, or refreshing a document in Internet Explorer while debugging it, can cause hangs or other unexpected behavior. Unlike in other debuggers, there is no Watch window for monitoring variables; they must be checked via manual commands.