Search results
Results from the WOW.Com Content Network
A bass reflex system (also known as a ported, vented box or reflex port) is a type of loudspeaker enclosure that uses a port (hole) or vent cut into the cabinet and a section of tubing or pipe affixed to the port. [1] [2] This port enables the sound from the rear side of the diaphragm to increase the efficiency of the system at low frequencies ...
MTX Audio loudspeaker enclosures (with rear panel reflex port tubes) which can mount 15-inch woofers, mid-range drivers and horn and/or compression tweeters. In this photo, only one driver is mounted. A cabinet with loudspeakers mounted in the holes. Number 1 is a mid-range driver. Number 2 is a high-range driver.
A loudspeaker (commonly referred to as a speaker or, more fully, a speaker system) is a combination of one or more speaker drivers, an enclosure, and electrical connections (possibly including a crossover network). The speaker driver is an electroacoustic transducer [1]: 597 that converts an electrical audio signal into a corresponding sound. [2]
These are provided so that one speaker cable can be plugged into the first jack and connected to the power amp; if the bassist wants to use a second cabinet, a second speaker cable is plugged into the second jack and then into second speaker. A small number of bass amps designed for the upright bass have both a 1/4" input for a piezoelectric ...
This article lists manufacturers of bass amplifiers, loudspeakers, and other amplification-related items such as preamplifiers. The amplifiers and loudspeakers used to amplify bass instruments (e.g., the bass guitar, double bass and similar instruments) are distinct from other types of amplification systems due to the particular challenges associated with low-frequency sound reproduction.
The effect is illustrated in Fig. 1, which shows a hard boundary at one end (the speaker) and the open-ended line vent at the other. The phase relationship between the bass driver and vent is in phase in the pass band until the frequency approaches the quarter wavelength, when the relationship reaches 90 degrees as shown.
Small [1] [2] and Hurlburt [3] have published the results of research into the analysis and design of passive-radiator loudspeaker systems. The passive-radiator principle was identified as being particularly useful in compact systems where vent realization is difficult or impossible, but it can also be applied satisfactorily to larger systems.
"It is difficult and costly to design and manufacture a time- and phase-accurate speaker system. Few of today’s high-end loudspeakers are time- and phase-accurate designs. The audio magazines need to appeal to a broad spectrum of advertisers including many who make speaker systems which are time incoherent.