Search results
Results from the WOW.Com Content Network
A ridge vent is a type of vent installed at the peak of a sloped roof which allows warm, humid air to escape a building's attic. Ridge vents are most common on shingled residential buildings. Ridge vents are also used in industrial warehouses to help release the hot air and help circulate comfortable air inside the building .
A whole house fan pulls air out of a building and forces it into the attic space or, in the case of homes without attics, through an opening in the roof or an outside wall. This forces air from the living areas into the attic and out through the gable and/or soffit vents, while at the same time drawing air from the outside into the living areas ...
An attic fan installed underneath a roof. A powered attic ventilator, or attic fan, is a ventilation fan that regulates the heat level of a building's attic by exhausting hot air. A thermostat is used to automatically turn the fan off and on, while sometimes a manual switch is used. An attic fan can be gable mounted or roof mounted. Additional ...
A warm roof is a roof that is not ventilated, [9] where the insulation is placed in line with the roof pitch. [10] A hot roof is a roof designed not to have any ventilation and has enough air-impermeable insulation in contact with the sheathing to prevent condensation [ 11 ] such as when spray foam insulation is applied directly to the under ...
Two king post trusses linked to support a roof. Key:1: ridge beam, 2: purlins, 3: common rafters. This is an example of a "double roof" with principal rafters and common rafters. A timber roof truss is a structural framework of timbers designed to bridge the space above a room and to provide support for a roof.
One common code requirement is that the total area of attic vents be equal to or greater than 1/150 of the floor area of the attic, with 50 percent or more of the vent area located in the upper portion of the attic. Vents and louvers should face away from prevailing winds to keep out driven rain. Soffit vents under the eaves normally provide ...
Compass rafter: A rafter curved or bowed on the top (the top surface of a rafter is called its "back") or both the top and bottom surfaces. Curb rafter: The upper rafters in a curb (kerb, gambrel, Mansard roof) roof. Hip rafter (angle rafter): The rafter in the corners of a hip roof. The foot of a hip rafter lands on a dragon beam.
Eaves must be designed for local wind speeds as the overhang can significantly increase the wind loading on the roof. [ 7 ] The line on the ground under the outer edge of the eaves is the eavesdrip , or dripline, and in typical building planning regulations defines the extent of the building and cannot oversail the property boundary.