Search results
Results from the WOW.Com Content Network
The M156 is the first automobile V8 engine designed autonomously by Mercedes-Benz subsidiary Mercedes-AMG, as previous AMG engines have always been based on original Mercedes engines. The engine was designed to be a naturally aspirated racing unit, and is also used in a number of high-performance AMG-badged Mercedes-Benz models.
Ford — Dual-Stage Intake (DSI), on their Duratec 2.5 and 3.0-litre V6s, and it was also found on the Yamaha V6 in the Taurus SHO. The Ford Modular V8 engines and the V6 Cologne use either the Intake Manifold Runner Control (IMRC) for four-valve engines, or the Charge Motion Control Valve (CMCV) for three-valve engines.
The graph above shows the intake runner pressure over 720 crank degrees of an engine with a 7-inch (180 mm) intake port/runner running at 4500 rpm, which is its torque peak (close to maximum cylinder filling and BMEP for this engine). The two pressure traces are taken from the valve end (blue) and the runner entrance (red).
The intake manifold fed both banks from inside the vee, but the exhaust ports had to pass between the cylinders to reach the outboard exhaust manifolds, since it did not use a t-head configuration. Such an arrangement transferred exhaust heat to the block, imposing a large cooling load; it required far more coolant and radiator capacity than ...
To support the new fuel system, the intake manifold was of a new design. Known colloquially as the "beer keg" or "kegger" manifold, the part was shaped like half of a beer barrel lying longitudinally atop the center of the V-shaped engine block. The intake runners, which supplied the fuel and air to each cylinder, fed each of the intake ports ...
air filter with hot-film air mass meter, one water-cooled turbocharger with electric boost pressure control mounted within the vee, sea-water tube intercooler, two separate cast alloy intake manifolds interconnected by a "feedthrough" system to equalise the pressure in the two cylinder banks, two-position variable swirl flaps integrated into ...
The first V engine, a two-cylinder V-twin, was designed by Wilhelm Maybach and used in the 1889 Daimler Stahlradwagen automobile. [1]The first V8 engine was produced in 1903, in the form of the Antoinette engine designed by Léon Levavasseur for racing boats and airplanes.
An inlet manifold or intake manifold (in American English) is the part of an internal combustion engine that supplies the fuel/air mixture to the cylinders. [1] The word manifold comes from the Old English word manigfeald (from the Anglo-Saxon manig [many] and feald [repeatedly]) and refers to the multiplying of one (pipe) into many.