Search results
Results from the WOW.Com Content Network
Yellow dots on white paper, produced by color laser printer (enlarged, dot diameter about 0.1 mm) Printer tracking dots, also known as printer steganography, DocuColor tracking dots, yellow dots, secret dots, or a machine identification code (MIC), is a digital watermark which many color laser printers and photocopiers produce on every printed page that identifies the specific device that was ...
The compound may be more stable than metallic silver and may also have a different color or tone. Different toning processes give different colors to the final print. In some cases, the printer may choose to tone some parts of a print more than others. [1] Toner also can increase the range of shades visible in a print without reducing the contrast.
In printing, bleed is printing that goes beyond the edge of where the sheet will be trimmed. In other words, the bleed is the area to be trimmed off. The bleed is the part on the side of a document that gives the printer a small amount of space to account for natural movement of the paper during guillotining, [1] and design inconsistencies ...
The expense of color film as compared to black-and-white and the difficulty of using it with indoor lighting combined to delay its widespread adoption by amateurs. In 1950, black-and-white snapshots were still the norm. By 1960, color was much more common but still tended to be reserved for travel photos and special occasions.
The printing cylinders are usually made from copper plated steel, which is subsequently chromed, and may be produced by diamond engraving; etching, or laser ablation. Gravure printing is known for its ability to produce high-quality, high-resolution images with accurate color reproduction and using viscosity control equipment during production.
Hand-colouring with watercolours requires the use of a medium to prevent the colours from drying with a dull and lifeless finish. Before the paint can be applied, the surface of the print must be primed so that the colours are not repelled. This often includes prepping the print with a thin coating of shellac, then adding grit before colouring ...
Contributing factors were the development of computer-aided drafting and printing, the speed of machine printing, and the introduction of larger xerographic machines or large format printers from companies like Ricoh and Xerox. The cost of blueline production materials and equipment, the fact that the prints themselves faded in sunlight, and ...
The combined lenticular print shows two or more images by changing the angle from which the print is viewed. If a sequence of images is used, it can even show a short animation. Though normally produced in sheet form by interlacing simple images or colors throughout the artwork, lenticular images can also be created in roll form with 3D effects ...