Search results
Results from the WOW.Com Content Network
A residual-current device (RCD), residual-current circuit breaker (RCCB) or ground fault circuit interrupter (GFCI) [a] is an electrical safety device that interrupts an electrical circuit when the current passing through a conductor is not equal and opposite in both directions, therefore indicating leakage current to ground or current flowing to another powered conductor.
Shaft sinking. A plan-view schematic of a mine shaft showing cage and skip compartments. Services may be housed in either of the four open compartments. Shaft mining or shaft sinking is the action of excavating a mine shaft from the top down, where there is initially no access to the bottom. [1] Shallow shafts, typically sunk for civil ...
A right-hand railroad switch with point indicator pointing to right Animated diagram of a right-hand railroad switch. Rail track A divides into two: track B (the straight track) and track C (the diverging track); note that the green line represents direction of travel only, the black lines represent fixed portions of track, and the red lines depict the moving components.
A drain-waste-vent system (or DWV) is the combination of pipes and plumbing fittings that captures sewage and greywater within a structure and routes it toward a water treatment system. It includes venting to the exterior environment to prevent a vacuum from forming and impeding fixtures such as sinks, showers, and toilets from draining freely ...
A common type of this style fitting is a "hex bushing" with a hex head for installation with a pipe wrench. A double-tapped bushing is more compact than a reducer but not as flexible. While a double-tapped bushing has a more minor female thread concentric to a larger male thread (and thus couples a smaller male end to a larger female), a ...
e. Thermodynamic heat pump cycles or refrigeration cycles are the conceptual and mathematical models for heat pump, air conditioning and refrigeration systems. A heat pump is a mechanical system that transmits heat from one location (the "source") at a certain temperature to another location (the "sink" or "heat sink") at a higher temperature. [1]
Each fixture usually has a characteristic means of connection. Normal plumbing practice is to install a valve on each water supply line before the fixture, and this is most commonly termed a stop or "service valve". The water supply to some fixtures is cold water only (such as water closets and urinals). Most fixtures also have a hot water supply.
Faucet is the most common term in the US, similar in use to "tap" in British English, e.g. "water faucet" (although the term "tap" is also used in the US).; Spigot is used by professionals in the trade (such as plumbers), and typically refers to an outdoor fixture.