Search results
Results from the WOW.Com Content Network
ArmaLite AR-15 with the charging handle located on top of the upper receiver, protected within the carrying handle and a 25-round magazine. 1973 Colt AR-15 SP1 rifle with "slab side" lower receiver (lacking raised boss around magazine release button) and original Colt 20-round magazine.
A disassembled Mauser action showing a partially disassembled receiver and bolt. In firearms terminology and law, the firearm frame or receiver is the part of a firearm which integrates other components by providing housing for internal action components such as the hammer, bolt or breechblock, firing pin and extractor, and has threaded interfaces for externally attaching ("receiving ...
The first version produced for commercial sale by Colt was the SP1 model AR-15 Sporter in .223 Remington, with a 20-inch (51 cm) barrel and issued with five-round magazines. [21] Initial sales of the Colt AR-15 were slow, primarily due to its fixed sights and carry handle that made scopes difficult to mount and awkward to use. [84]
The AR-15 uses an L-type flip, aperture rear sight and it is adjustable with two settings, 0 to 300 meters and 300 to 400 meters. [16] The front sight is a post adjustable for elevation. The rear sight can be adjusted for windage. The sights can be adjusted with a bullet tip or pointed tool. The AR-15 can also mount a scope on the carrying handle.
The CAR-15 name was an attempt to re-associate the AR-15 name with Colt, since the AR initially stood for "Armalite Rifle" the original manufacturer of the Armalite AR-15. Colt later abandoned the CAR-15 concept, but continued to make carbine variations, using the "M16" brand for select-fire models and the "Colt AR-15" brand for semi-automatic ...
The AR-57 PDW upper is a new design on AR-15/M16 rifles, blending the AR-15/M16 lower with a lightweight, monolithic upper receiver system chambered in 5.7×28mm. This model is also sold as a complete rifle, supplied with two 50-round P90 magazines. [1]
The AR Lower V5 is a 3D printed lower receiver for the AR-15 rifle. [1] It was created in March 2013 Defense Distributed printed using the Stratasys Dimension SST 3-D printer [1] [2] using the fused deposition modeling (FDM) method. [2] The receiver was able to handle enough stress to fire more than 600 rounds. [1]
The configuration at the top is with a SBR upper with a length of 20 inches with the configuration below consisting of a 16 inch upper with a length of 26.5 inches. [1] The initial a prototype lacks a safety and adjustable outside of interchangeable butt pads, but the creators say "it should work without issue".