Search results
Results from the WOW.Com Content Network
The Egyptian equivalent of the foot—a measure of four palms or 16 digits—was known as the djeser and has been reconstructed as about 30 cm (11.8 in). The Greek foot (πούς, pous) had a length of 1 / 600 of a stadion, [12] one stadion being about 181.2 m (594 ft); [13] therefore a foot was, at the time, about 302 mm (11.9 in). Its ...
The basic unit of Roman linear measurement was the pes (plural: pedes) or Roman foot. Investigation of its relation to the English foot goes back at least to 1647, when John Greaves published his Discourse on the Romane foot .
The agricultural foot was reduced to 10 ⁄ 11 of its former size, causing the rod, pole or perch to become 16 + 1 ⁄ 2 (rather than the older 15) agricultural feet. The furlong and the acre, once it became a measure of the size of a piece of land rather than its value, remained relatively unchanged. In the last thousand years, three principal ...
During the Anglo-Saxon period, the North German foot of 13.2 inches (335 millimetres) was the nominal basis for other units of linear measurement. The foot was divided into 4 palms or 12 thumbs. A cubit was 2 feet, an elne 4 feet. The rod was 15 Anglo-Saxon feet, the furlong 10 rods.
For measuring length, the U.S. customary system uses the inch, foot, yard, and mile, which are the only four customary length measurements in everyday use. From 1893, the foot was legally defined as exactly 1200 ⁄ 3937 m (approximately 0.304 8006 m). [13] Since July 1, 1959, the units of length have been defined on the basis of 1 yd = 0.9144 ...
In antiquity, systems of measurement were defined locally: the different units might be defined independently according to the length of a king's thumb or the size of his foot, the length of stride, the length of arm, or maybe the weight of water in a keg of specific size, perhaps itself defined in hands and knuckles. The unifying ...
The chain is the unit of linear measurement for the survey of the public lands as prescribed by law. All returns of measurement in the rectangular system are made in the true horizontal distance in links, chains, and miles. The only exceptions to this rule are special requirements for measurement in feet in mineral surveys and townsite surveys ...
It is possible to group official measurement systems for large societies into historical systems that are relatively stable over time, including: the Babylonian system, the Egyptian system, the Phileterian system of the Ptolemaic age, the Olympic system of Greece, the Roman system, the British system, and the metric system.