Ad
related to: what a resistor does a switch control unit make
Search results
Results from the WOW.Com Content Network
For example, a 10 ohm resistor connected in parallel with a 5 ohm resistor and a 15 ohm resistor produces 1 / 1/10 + 1/5 + 1/15 ohms of resistance, or 30 / 11 = 2.727 ohms. A resistor network that is a combination of parallel and series connections can be broken up into smaller parts that are either one or the other.
When the switch is open the voltage of the gate input is pulled up to the level of Vin. When the switch is closed, the input voltage at the gate goes to ground. In electronic logic circuits, a pull-up resistor (PU) or pull-down resistor (PD) is a resistor used to ensure a known state for a signal. [1]
A resistance decade box or resistor substitution box is a unit containing resistors of many values, with one or more mechanical switches which allow any one of various discrete resistances offered by the box to be dialed in. Usually the resistance is accurate to high precision, ranging from laboratory/calibration grade accuracy of 20 parts per ...
A shunt resistor, which has been connected in parallel across the filament before it burnt out, will then short out to bypass the burnt filament and allow the rest of the string to light. If too many lights burn out however, a shunt will also burn out, requiring the use of a multimeter to find the point of failure.
The actuator can adjust the phase angle of 0 ° el. (maximum power) up to 180 ° el. (no power). In a 50 Hz mains the controller switches every 20 ms and shows very fast behavior. As a result of the voltage flanks during switch-on, disadvantages such as EMC interference potential or control voltage output also result in ohmic loads.
A solid state relay (SSR) is an electronic switching device that switches on or off when an external voltage (AC or DC) is applied across its control terminals. They serve the same function as an electromechanical relay , but solid-state electronics contain no moving parts and have a longer operational lifetime.
The most widely used electronic switch in digital circuits is the metal–oxide–semiconductor field-effect transistor (MOSFET). [2] The analogue switch uses two MOSFET transistors in a transmission gate arrangement as a switch that works much like a relay, with some advantages and several limitations compared to an electromechanical relay.
A current dependent resistor formed of a fine wire in an envelope, useful for regulating current. humidistat A switch that operates automatically on detecting a change in moisture content of the air. HVAC High Voltage Alternating Current; depending on context, this could be hundreds or hundreds of thousands of volts. HVDC converter station
Ad
related to: what a resistor does a switch control unit make