enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. 0-10 V lighting control - Wikipedia

   en.wikipedia.org/wiki/0-10_V_lighting_control

   Dimming fluorescent ballasts and dimming LED drivers often use 0–10 V control signals to control dimming functions. In many cases, the dimming range of the power supply or ballast is limited. If the light output can only be dimmed from 100% down to 10%, there must be a switch or relay available to kill power to the system and turn the light ...

3. Dimmer - Wikipedia

   en.wikipedia.org/wiki/Dimmer

   This circuit is called a leading-edge dimmer or forward phase dimming. Waveform of the output voltage of a thyristor dimmer set for 60 volts RMS output, with 120 V input. The red trace shows the output device switching on about 5.5 ms after the input (blue) voltage crosses zero.

4. Potentiometer - Wikipedia

   en.wikipedia.org/wiki/Potentiometer

   A potentiometer was often used to adjust "vertical hold", which affected the synchronization between the receiver's internal sweep circuit (sometimes a multivibrator) and the received picture signal, along with other things such as audio-video carrier offset, tuning frequency (for push-button sets) and so on. It also helps in frequency ...

5. RDM (lighting) - Wikipedia

   en.wikipedia.org/wiki/RDM_(lighting)

   Remote Device Management (RDM) is an addition to the DMX512 control protocol for stage lighting equipment, introduced in 2006. DMX512 was developed in the late 1980s as a standard protocol for lighting consoles to communicate with dimmers, but has since been used for more complex applications, including the control of intelligent lighting fixtures.

6. Trimmer (electronics) - Wikipedia

   en.wikipedia.org/wiki/Trimmer_(electronics)

   The skeleton potentiometer works like a regular circular potentiometer, but is stripped of its enclosure, shaft, and fixings. The full movement of a skeleton potentiometer is less than a single turn. The other type is the multi-turn potentiometer which moves the slider along the resistive track via a gearing arrangement. The gearing is such ...

7. LED circuit - Wikipedia

   en.wikipedia.org/wiki/LED_circuit

   The maximum continuous-on current is shown on LED datasheets, for example 20 mA (0.020 A) is common for most small LEDs. Many circuits operate LEDs at less than the specified maximum current to save power, or to reduce brightness, or to use a common resistor value. For indoor use, tiny surface mount high-efficiency LEDs can easily light up with ...