Search results
Results from the WOW.Com Content Network
Essentially, a chopper is an electronic switch that is used to interrupt one signal under the control of another. In power electronics applications, since the switching element is either fully on or fully off, its losses are low and the circuit can provide high efficiency. However, the current supplied to the load is discontinuous and may ...
Economy 7 meter and radio teleswitch, right. A radio teleswitch is a device used in the United Kingdom primarily to allow electricity suppliers to switch large numbers of electricity meters between different tariff rates, by broadcasting an embedded signal in broadcast radio signals.
0.12 W/cm 3, 88 W/kg [28] Smaller than linear power supply. Compared to linear, a SMPS that is 20 kHz is 1/4, 100–200 kHz is 1/8, and 200 kHz–1 MHz types can be even smaller. [28]: 5–8 A transformer's power handling capacity of given size and weight increases with frequency provided that hysteresis losses can be kept down. Therefore, a ...
K.W. Electronics was a British manufacturer of amateur radio equipment founded in the mid-1950s by the late Rowley Shears G8KW. It was based in Dartford , Kent , and manufactured a wide range of high frequency band receivers, transmitters and accessory equipment.
The most widely used electronic switch in digital circuits is the metal–oxide–semiconductor field-effect transistor (MOSFET). [2] The analogue switch uses two MOSFET transistors in a transmission gate arrangement as a switch that works much like a relay, with some advantages and several limitations compared to an electromechanical relay.
The commutation cell is the basic structure in power electronics.It is composed of two electronic switches (today, a high-power semiconductor, not a mechanical switch).It was traditionally referred to as a chopper, but since switching power supplies became a major form of power conversion, this new term has become more popular.
An electrical meter with integral AC current clamp is known as a clamp meter, clamp-on ammeter, tong tester, or colloquially as an amp clamp. A clamp meter measures the vector sum of the currents flowing in all the conductors passing through the probe, which depends on the phase relationship of the currents. Only one conductor is normally ...
In electrical engineering, a disconnector, disconnect switch or isolator switch is a type of switching device with visible contacts, used to ensure that an electrical circuit is completely de-energized for service or maintenance.