Search results
Results from the WOW.Com Content Network
A dead weight tester (DWT) is a calibration standard method that uses a piston cylinder on which a load is placed to make an equilibrium with an applied pressure underneath the piston. Deadweight testers are secondary standards which means that the pressure measured by a deadweight tester is defined through other quantities: length, mass and ...
The first stage regulator body generally has several low-pressure outlets (ports) for second-stage regulators, BCD inflators and other equipment; and one or more high-pressure outlets, which allow a submersible pressure gauge (SPG), gas-integrated diving computer or remote wireless pressure transducer to measure the cylinder pressure.
A hydrostatic test involves pressurising the cylinder to its test pressure (usually 5/3 or 3/2 of the working pressure) and measuring its volume before and after the test. A permanent increase in volume above the tolerated level means the cylinder fails the test and must be permanently removed from service. [3]: sect. 5.7.3
Strain-Gauge: Strain gauge based pressure sensors also use a pressure sensitive element where metal strain gauges are glued on or thin-film gauges are applied on by sputtering. This measuring element can either be a diaphragm or for metal foil gauges measuring bodies in can-type can also be used.
Automatic calibration - A U.S. serviceman using a 3666C auto pressure calibrator. An automatic pressure calibrator [13] is a device that combines an electronic control unit, a pressure intensifier used to compress a gas such as Nitrogen, a pressure transducer used to detect desired levels in a hydraulic accumulator, and accessories such as ...
Gauges for measuring pressure in the range 20–30 standard atmospheres (15,000–23,000 mmHg) have been built. [13] A 23-metre-tall mercury column is difficult to read and suffers from inaccuracies caused by different parts of the column being at different temperatures. A more compact mercury pressure gauge suitable for high pressure was built ...
The test cartridge must be inserted into the chamber in such a way that the hole in the test cartridge case lines up with a gas port hole that channels the gas pressure from the cartridge case to the face of the sensor. The measurement accuracy of the pressure measurements with 21st century high-pressure sensors is expected to be ≤ 2%. [7]
A permanent downhole gauge (PDG) is a pressure and/or temperature gauge permanently installed in an oil or gas well. [1] These gauges are typically installed in the tubing in the well and can measure the tubing pressure, annulus pressure, or both.