Search results
Results from the WOW.Com Content Network
The taper rate for all NPT threads is 1 inch of diameter in 16 inches of length (3 ⁄ 4 inch per foot or 62.5 millimeters per meter) measured by the change of diameter (of the pipe thread) over distance of thread. The half-angle (between the taper surface and the axis of the pipe) is arctan(1 ⁄ 32) ≈ 1.7899° ≈ 1° 47′.
DIN 28610-1: Ductile iron pressure pipes with socket with cement-mortar lining for gas and water pipelines; dimensions and masses: Withdrawn: DIN EN 545, DIN EN 969: EN 545, EN 969: DIN 28610-2: Ductile iron pressure pipes with socket for gas and water pipelines rated for pressures over 4 bar up to and including 16 bar; dimensions and masses ...
The rate of taper is 1:20 on diameter, in other words 0.600" on diameter per foot, .050" on diameter per inch. Tapers range from a Number 2 to a Number 20. The diameter of the big end in inches is always the taper size divided by 8, the small end is always the taper size divided by 10 and the length is the taper size divided by 2.
In mechanical engineering, the thread angle of a screw is the included angle between the thread flanks, measured in a plane containing the thread axis. [1] This is a defining factor for the shape of a screw thread .
Please note that the correct way to calculate the angle is: The taper is the change in the size of the diameter as you travel down the axis of the taper. So, take 1/2 the change size (1.75") and divide that by 12", arctan of the result is 1/2 the included angle. So 16.5942899... is correct.
Many material or standard specifications include a number of different UNS numbers that may be used within that specification. For example: UNS S30400 (SAE 304, Cr/Ni 18/10, Euronorm 1.4301 stainless steel) could be used to make stainless steel bars ( ASTM A276 ) or stainless steel plates for pressure vessels ( ASTM A240 ) or pipes ( ASTM A312 ).
For a taper thread, it is the diameter at the "gauge length" (plus/minus one thread pitch) from the small end of the thread. The taper is 1:16, meaning that for each 16 units of measurement increase in the distance from the end, the diameter increases by 1 unit of measurement.
cast iron: No longer a commonly used abbreviation. Better to spell out for clarity. CL or ℄ centreline or centerline; class: 1. Center line, the central axis of a feature. 2. Class, for example, "paint per spec XYZ revision C type 1 class 2" may be abbreviated as "paint per spec XYZ REV C TY 1 CL 2" or even in some cases "paint per spec XYZ-C ...