Search results
Results from the WOW.Com Content Network
MCA-Jet was a simpler system that sent the same air/fuel mixture to all intake and MCA-Jet valves. Each MCA-Jet valve is quite small and may be prone to carbon build-up, causing the MCA-Jet valve(s) to stick open. If a Mitsubishi-designed engine has low compression, the MCA-Jet valve(s) could be the cause. Each MCA-Jet valve and valve seat are ...
"MCA" stood for "Mitsubishi Clean Air", reflecting Japan's new air quality laws. The MCA-II was cleaner yet, and with balance shafts it also offered a much smoother run, at the loss of a few horsepower. The Sports engine did not meet the stricter emissions laws, which led to the demise of the Skipper.
Using the PRV method of control, means that the pressure of the feed oil must be below a critical value (usually controlled by other valves which can leak out excess oil back to tank if it exceeds the critical value). The valve opens at a certain pressure and oil is kept moving at a constant rate into the bearing chamber.
The quantity of bleed air flowing to the AC pack is regulated by the flow control valve (FCV). One FCV is installed for each PACK. A normally closed isolation valve prevents air from the left bleed system from reaching the right PACK (and vice versa), although this valve may be opened in the event of loss of one bleed system.
Vacuum systems usually consist of gauges, vapor jet and pumps, vapor traps and valves along with other extensional piping. A vessel that is operating under vacuum system may be any of these types such as processing tank, steam simulator, particle accelerator, or any other type of space that has an enclosed chamber to maintain the system in less than atmospheric gas pressure.
The solenoid valve regulates the amount of oil pumped by the cam action to either the valve or a bypass reservoir. When pressurized, the hydraulic line behaves like a solid body and transmits the lift schedule imparted by the intake cam directly to the intake valve. When the solenoid is disengaged, a spring takes over valve actuation duties.
Aerospace engineering – is the primary field of engineering concerned with the development of aircraft and spacecraft. [13] It has two major and overlapping branches: Aeronautical engineering and Astronautical Engineering. Avionics engineering is similar, but deals with the electronics side of aerospace engineering.
Those with the later, cleaner yet, "MCA-Jet" system were called G32B. Later, the G32B also came in a fuel injected , turbocharged model. For competition, a version of the 4G32 engine was made with a DOHC eight-valve cylinder head, and fitted with two twin-choke 40 mm (1.6 in) Solex sidedraft carburettors.