Search results
Results from the WOW.Com Content Network
Thus, the outer diameter of a catheter in millimeters can be calculated by dividing the French size by 3. [2] For example, a catheter with a French size of 9 would have an outer diameter of approximately 3 mm. While the French scale aligns closely with the metric system, it introduces redundancy and the potential for rounding errors.
A few sizes are close enough to interchange for most purposes, such as 19 mm (close to 3 ⁄ 4 inch (19.05 mm)), 8 mm (close to 5 ⁄ 16 inch (7.94 mm)) and 4 mm (close to 5 ⁄ 32 inch (3.97 mm)). In reality, a wrench with a width across the flats of exactly 15 mm would fit too tightly to use on a bolt with a width across the flats of 15 mm.
The major diameter is given by 6p 1.2, [4]: 12 rounded to two significant figures in mm and the hex head size (across the flats) is 1.75 times the major diameter. BA sizes are specified by the following British Standards: BS 57:1951 — B.A. screws, bolts and nuts
Below is a comprehensive drill and tap size chart for all drills and taps: Inch, imperial, and metric, up to 36.5 millimetres (1.44 in) in diameter. In manufactured parts, holes with female screw threads are often needed; they accept male screws to facilitate the building and fastening of a finished assembly.
Tools and fasteners with sizes measured in inches are sometimes called "SAE bolts" or "SAE wrenches" to differentiate them from their metric counterparts. The Society of Automotive Engineers (SAE) originally developed fasteners standards using U.S. units for the U.S. auto industry; the organization now uses metric units. [33]
The metric standard used the same thread geometry as the USS standard but differed in that the dimensions and pitch were based on metric units. In 1906, the A.L.A.M developed what would be the SAE thread standard for threaded fasteners based on the USS standard but with a finer thread pitch. [6] [7]
A standard metric (concrete) block is 190 mm wide, 390 mm long, and 190 mm high, which allows for 10 mm mortar joints in between bricks, giving a standard unit size of 200 mm square by 400 mm long. [3] A standard metric brick is 90 by 57 by 190 mm; with 10 mm of mortar, that produces a standard unit of 100 mm x 200 mm. [3]
The Australian building trades adopted the metric system in 1966 and the units used for measurement of length are meters (m) and millimeters ... chain of 66 feet (20 ...