Ad
related to: car heater will not turn off two lights on ground zero startyourmechanic.com has been visited by 10K+ users in the past month
138 S Wheatland Ave, Columbus, OH · Directions · (614) 963-9299
Search results
Results from the WOW.Com Content Network
The emergency stop signal is automatically activated if the vehicle speed is greater than 50 km/h (31 mph) and the emergency braking logic defined by regulation No. 13 (heavy vehicles), 13H (light vehicles), or 78 (motorcycles) is activated; the ESS may be displayed when a light vehicle's deceleration is greater than 6 m/s 2 (20 ft/s 2) or a ...
Thermal switches are included in turn signals on older vehicles, some light fixtures, particularly with recessed lights, where excessive heat is most likely to occur. This may lead to "cycling" , where a light turns off and back on every few minutes. Flashing incandescent Christmas lights take advantage of this
Many modern engines automatically activate the glowplugs when the operator unlocks the vehicle or opens the door to the car, thus simplifying the process and shortening the waiting time the operator has to wait before the engine will start. In addition, the time needed to pre-heat the engine is typically 6-8 seconds. [2]
Gasoline is brought to the heater from the vehicle's fuel system. A fan blows air into a combustion chamber, where a glow plug or similar ignition device lights the gasoline/air mixture. Ducting around this contains a second fan, which blows air warmed by contact with the combustion chamber into the interior of the vehicle.
Full-voltage vs. parking light headlamp on European-market Volkswagen, 2007. Depending on prevailing regulations and equipment, vehicles may implement the daytime-running light function by functionally turning on specific lamps, by operating low-beam headlamps or fog lamps at full or reduced intensity, by operating high-beam headlamps at reduced intensity, or by steady-burning operation of the ...
Electrical cord for powering a block heater. A block heater is used in cold climates to warm an engine prior to starting. They are mostly used for car engines; however, they have also been used in aircraft engines. The most common design of block heater is an electrical heating element embedded in the engine block.
The temperature of the air entering the vehicle's interior can be controlled by using a valve limiting the amount of coolant that goes through the heater core. Another method is blocking off the heater core with a door, directing part (or all) of the incoming air around the heater core completely, so it does not get heated (or re-heated if the ...
In natural gas furnaces, water heaters, and room heating systems, a safety cut-off switch is normally included so that the gas supply to the pilot and heating system is shut off by an electrically operated valve if the pilot light goes out. This cut-off switch usually detects the pilot light in one of several ways: A flame rectification device. [2]
Ad
related to: car heater will not turn off two lights on ground zero startyourmechanic.com has been visited by 10K+ users in the past month
138 S Wheatland Ave, Columbus, OH · Directions · (614) 963-9299