Search results
Results from the WOW.Com Content Network
This relationship between water activity and moisture content at a given temperature is called the moisture sorption isotherm. These curves are determined experimentally and constitute the fingerprint of a food system. [2] BET theory (Brunauer-Emmett-Teller) provides a calculation to describe the physical adsorption of gas molecules on a solid ...
The moisture content of grains is an essential property in food storage. The moisture content that is safe for long-term storage is 12% for corn, sorghum, rice and wheat and 11% for soybean [ 1 ] At a constant relative humidity of air, the EMC will drop by about 0.5% for every increase of 10 °C air temperature.
In food science, water activity (a w) of a food is the ratio of its vapor pressure to the vapor pressure of water at the same temperature, both taken at equilibrium. [1] Pure water has a water activity of one. Put another way, a w is the equilibrium relative humidity (ERH) expressed as a fraction instead of as a percentage.
T-S diagram of a station in the North Pacific. In oceanography, temperature-salinity diagrams, sometimes called T-S diagrams, are used to identify water masses.In a T-S diagram, rather than plotting each water property as a separate "profile," with pressure or depth as the vertical coordinate, potential temperature (on the vertical axis) is plotted versus salinity (on the horizontal axis).
The saturation with respect to water cannot be measured much below –50 °C, so manufacturers should use one of the following expressions for calculating saturation vapour pressure relative to water at the lowest temperatures – Wexler (1976, 1977), [1] [2] reported by Flatau et al. (1992)., [3] Hyland and Wexler (1983) or Sonntag (1994 ...
* And when keeping food warm or letting it sit out at room temperature, always keep in mind the cooking "danger zone," of which few home cooks are aware. Food should never stay between 41-135 ...
Saturated surface dry (SSD) is defined as the condition of an aggregate in which the surfaces of the particles are "dry" (i.e., they will neither absorb any of the mixing water added; nor will they contribute any of their contained water to the mix [11]), but the inter-particle voids are saturated with water.
where temperature T is in degrees Celsius (°C) and saturation vapor pressure P is in kilopascals (kPa). According to Monteith and Unsworth, "Values of saturation vapour pressure from Tetens' formula are within 1 Pa of exact values up to 35 °C." Murray (1967) provides Tetens' equation for temperatures below 0 °C: [3]