enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Probe 16 - Wikipedia

   en.wikipedia.org/wiki/Probe_16

   Robin Gibbons lent Stanley Kubrick his Probe 16 (AB/4) for use in filming in his 1971 film, A Clockwork Orange.In the film, it is referred to as "Durango 95". [3] In the TV programme Top Gear (Series 5, second episode, aired 31 October 2004), the one used in the film was nominated for restoration in the "Restoration Rip-off" feature, but it was out-voted by Paddy Hopkirk's Mini for restoration ...

3. Factory tint - Wikipedia

   en.wikipedia.org/wiki/Factory_tint

   Factory tint, officially known as privacy glass, is an electrical process called "deep dipping" that involves dying the inside of automotive glass with a dark pigment. Factory tint is standard on the rear half of many new vehicles. With a common visual light transmission (VLT) of 15–26%, privacy glass is installed to provide passengers and ...

4. Brake bleeding - Wikipedia

   en.wikipedia.org/wiki/Brake_bleeding

   A brake bleed screw is normally mounted at the highest point on each cylinder or caliper. There are five main methods of bleeding: [1] The pump and hold method, the brake pedal is pressed while one bleed screw at a time is opened, allowing air to escape. The bleed screw must be closed before releasing the pedal, or a one-way valve must be fitted.

5. Brake fluid - Wikipedia

   en.wikipedia.org/wiki/Brake_fluid

   The brake fluid in the tubes, in turn, pressurizes the brake slave cylinders, which are on each wheel. [22] [23] The slave cylinder pistons press down the brake pads. They encompass and compress the brake disk, and the rotation of the wheels slows down. In addition to transmitting pressure, brake fluid also keeps the brake system working optimally.

6. Automatic bleeding valve - Wikipedia

   en.wikipedia.org/wiki/Automatic_bleeding_valve

   Automatic valves are used to release trapped air as it collects. They are not a substitute for bleeding a system manually when it is first filled during commissioning, nor for remedial bleeding if the system becomes choked with trapped air. In those cases, individual bleed screws on each radiator, or high pipe run, are opened manually.

7. Bleeder resistor - Wikipedia

   en.wikipedia.org/wiki/Bleeder_resistor

   In electronics, a bleeder resistor, bleeder load, leakage resistor, capacitor discharge resistor or safety discharge resistor is a resistor connected in parallel with the output of a high-voltage power supply circuit for the purpose of discharging the electric charge stored in the power supply's filter capacitors when the equipment is turned off, for safety reasons.