Search results
Results from the WOW.Com Content Network
Membrane distillation (MD) is a thermally driven separation process in which separation is driven by phase change. A hydrophobic membrane presents a barrier for the liquid phase , allowing the vapour phase (e.g. water vapour) to pass through the membrane's pores. [ 1 ]
Generally, dead-end filtration is used for feasibility studies on a laboratory scale. The dead-end membranes are relatively easy to fabricate which reduces the cost of the separation process. The dead-end membrane separation process is easy to implement and the process is usually cheaper than cross-flow membrane filtration.
Multi-stage flash distillation (MSF) is a water desalination process that distills sea water by flashing a portion of the water into steam in multiple stages of what are essentially countercurrent heat exchangers. Current MSF facilities may have as many as 30 stages.
The configuration of this stack can be either horizontal or vertical. The feed water passes in parallel through all the cells, providing a continuous flow of permeate and brine. Although this is a well-known process electrodialysis is not commercially suited for seawater desalination, because it can be used only for brackish water (TDS < 1000 ...
A McCabe–Thiele diagram for the distillation of a binary (two-component) feed is constructed using the vapor-liquid equilibrium (VLE) data—which is how vapor is concentrated when in contact with its liquid form—for the component with the lower boiling point. Figure 1: Typical McCabe–Thiele diagram for distillation of a binary feed
Packed bed and fluidized bed membrane reactors. Generally, membrane reactors can be classified based on the membrane position and reactor configuration. [1] Usually there is a catalyst inside: if the catalyst is installed inside the membrane, the reactor is called catalytic membrane reactor (CMR); [1] if the catalyst (and the support) are packed and fixed inside, the reactor is called packed ...
The term pervaporation is a portmanteau of the two steps of the process: (a) permeation through the membrane by the permeate, then (b) its evaporation into the vapor phase. . This process is used by a number of industries for several different processes, including purification and analysis, due to its simplicity and in-line natu
Even distillation does not completely purify water, because of contaminants with similar boiling points and droplets of unvapourised liquid carried with the steam. However, 99.9% pure water can be obtained by distillation. Direct contact membrane distillation (DCMD) passes heated seawater along the surface of a hydrophobic polymer membrane ...