Search results
Results from the WOW.Com Content Network
Engineering Equation Solver (EES) is a commercial software package used for solution of systems of simultaneous non-linear equations.It provides many useful specialized functions and equations for the solution of thermodynamics and heat transfer problems, making it a useful and widely used program for mechanical engineers working in these fields.
The incorporation of a subcooling stage after the receiver reduces even more the chances to observe flash gas. [5] This subcooling may be done in a reserved portion of the main condenser, or separately with a heat exchanger. Some receivers may incorporate an internal heat exchanger that draws heat form the subcooled liquid to superheat the gas ...
The term subcooling (also called undercooling) refers to the intentional process of cooling a liquid below its normal boiling point. For example, water boils at 373 K; at room temperature (293 K) liquid water is termed "subcooled". Subcooling is a common stage in refrigeration cycles and steam turbine cycles.
A pivot table in BOEMax, a Basis of Estimate software package. To create a BOE companies, throughout the past few decades, have used spreadsheet programs and skilled cost analysts to enter thousands of lines of data and create complex algorithms to calculate the costs. These positions require a high level of skill to ensure accuracy and ...
Superheating can occur when an undisturbed container of water is heated in a microwave oven.At the time the container is removed, the lack of nucleation sites prevents boiling, leaving the surface calm.
The heat pump itself can be improved by increasing the size of the internal heat exchangers, which in turn increases the efficiency (and the cost) relative to the power of the compressor, and also by reducing the system's internal temperature gap over the compressor. Obviously, this latter measure makes some heat pumps unsuitable to produce ...
If a gaseous emission sample is analyzed and found to contain water vapor and a pollutant concentration of say 40 ppmv, then 40 ppmv should be designated as the "wet basis" pollutant concentration. The following equation can be used to correct the measured "wet basis" concentration to a " dry basis " concentration: [ 3 ]
The diagram was created in 1904, when Richard Mollier plotted the total heat [4] H against entropy S. [5] [1]At the 1923 Thermodynamics Conference held in Los Angeles it was decided to name, in his honor, as a "Mollier diagram" any thermodynamic diagram using the enthalpy as one of its axes.