Search results
Results from the WOW.Com Content Network
Advanced Extremely High Frequency (AEHF) is a constellation of communications satellites operated by the United States Space Force.They are used to relay secure communications for the United States Armed Forces, the British Armed Forces, the Canadian Armed Forces, the Netherlands Armed Forces and the Australian Defence Force. [3]
Virtual Antenna Mapping (VAM) is used in wireless telecom networks. Typically when MIMO is deployed using two power Amplifier for two transmit antennae, there is a risk that both power amplifiers are not optimally used. Non-MIMO traffic would be using up to half of the available power whereas MIMO traffic could use the full power.
In this case, an external push–pull amplifier can be controlled by the current into and out of the operational amplifier. Thus, the operational amplifier may itself operate within its factory specified bounds while still allowing the negative feedback path to include a large output signal well outside of those bounds. [1]
Atheros Intellon 1200 AFE-Chip as companion for an INT 5500 PowerLine-IC. An analog front-end (AFE or analog front-end controller AFEC) is a set of analog signal conditioning circuitry that uses sensitive analog amplifiers, often operational amplifiers, filters, and sometimes application-specific integrated circuits for sensors, radio receivers, and other circuits to provide a configurable and ...
The effects of frequency-selective channel conditions, for example fading caused by multipath propagation, can be considered as constant (flat) over an OFDM sub-channel if the sub-channel is sufficiently narrow-banded (i.e., if the number of sub-channels is sufficiently large).
The DSCS communications payload includes six independent Super High Frequency (SHF) transponder channels that cover a 500 MHz bandwidth. Three receive and five transmit antennas provide selectable options for Earth coverage, area coverage and/or spot beam coverage. A special purpose single-channel transponder is also on board. [9]
Working with Jock Herd, in 1926 Watt added an amplifier to each of the two arms of the antenna, and sent those signals into the X and Y channels of the oscilloscope. As hoped, the radio signal produced a pattern on the screen that indicated the direction of the strike, and the slow-decay phosphor gave the operator ample time to measure it ...
A communications satellite's transponder is the series of interconnected units that form a communications channel between the receiving and the transmitting antennas. [1] It is mainly used in satellite communication to transfer the received signals. A transponder is typically composed of: an input band-limiting device (an input band-pass filter),