Search results
Results from the WOW.Com Content Network
A setpoint can be any physical quantity or parameter that a control system seeks to regulate, such as temperature, pressure, flow rate, position, speed, or any other measurable attribute. In the context of PID controller , the setpoint represents the reference or goal for the controlled process variable.
As long as the process variable is below the setpoint, the control output is set to the higher value. As soon as it rises above the setpoint, the control output is set to the lower value. Ideally, the output waveform is nearly square, spending equal time above and below the setpoint.
DCSs are connected to sensors and actuators and use setpoint control to control the flow of material through the plant. A typical application is a PID controller fed by a flow meter and using a control valve as the final control element. The DCS sends the setpoint required by the process to the controller which instructs a valve to operate so ...
The operator interfaces which enable monitoring and the issuing of process commands, such as controller setpoint changes, are handled through the SCADA computer system. The subordinated operations, e.g. the real-time control logic or controller calculations, are performed by networked modules connected to the field sensors and actuators .
A feedback control loop is directly controlled by the RTU or PLC, but the SCADA software monitors the overall performance of the loop. For example, a PLC may control the flow of cooling water through part of an industrial process to a set point level, but the SCADA system software will allow operators to change the set points for the flow.
Set point or setpoint may refer to: Set point (tennis) , a tennis term meaning one player is one point away from winning a set Set point (endocrinology) , a term encompassing a number of quantities (e.g. body weight , body temperature ) where the endocrine system contributes to regulation and homeostasis .
It does not use feedback to determine if its output has achieved the desired goal of the input command or process setpoint. There are many open-loop controls, such as on/off switching of valves, machinery, lights, motors or heaters, where the control result is known to be approximately sufficient under normal conditions without the need for ...
The OPC specification was based on the OLE, COM, and DCOM technologies developed by Microsoft Corporation for the Microsoft Windows operating system family. The specification defined a standard set of objects, interfaces e.g. IDL and methods for use in process control and manufacturing automation applications to facilitate interoperability.