Search results
Results from the WOW.Com Content Network
A key switch 3-way socket has the switch incorporated in the lamp socket and requires no external wiring between switch and socket. This would be typical in a 3-way floor-standing floor lamp. A 3-way socket that is to be wired to a separate 3-way 2-circuit switch, is called a keyless 3-way socket. [4]
The switch is controlled by a PWM (Pulse Width Modulation) signal, which alternately turns the switch on and off at a rapid rate. The relative proportion of off time vs. on time determines brightness. For example, if the switch is off 10% of the time, the resulting control signal would be the equivalent of 1 V produced with a variable resistor.
Many memory consoles have a bank of faders. These faders can be programmed to control a single channel (a channel is a lighting designer's numerical name for a dimmer or group of dimmers) or a group of channels (known as a ""submaster""). The console may also have provision to operate in analog to a manual desk for programming scenes or live ...
This circuit is called a leading-edge dimmer or forward phase dimming. Waveform of the output voltage of a thyristor dimmer set for 60 volts RMS output, with 120 V input. The red trace shows the output device switching on about 5.5 ms after the input (blue) voltage crosses zero.
In contrast to a simple light switch, which is a single pole, single throw (SPST) switch, multiway switching uses switches with one or more additional contacts and two or more wires are run between the switches. When the load is controlled from only two points, single pole, double throw (SPDT) switches are used.
Two light switches in one box. The switch on the right is a dimmer switch. The switch box is covered by a decorative plate. The first light switch employing "quick-break technology" was invented by John Henry Holmes in 1884 in the Shieldfield district of Newcastle upon Tyne. [1]
Digital Serial Interface (DSI) is a protocol for the controlling of lighting in buildings (initially electrical ballasts).It was created in 1991 by Austrian company Tridonic and is based on Manchester-coded 8-bit protocol, data rate of 1200 baud, 1 start bit, 8 data bits (dimming value), 4 stop bits, and is the basis of the more sophisticated protocol Digital Addressable Lighting Interface (DALI).
Digital Addressable Lighting Interface (DALI) is a trademark for network-based products that control lighting.The underlying technology was established by a consortium of lighting equipment manufacturers as a successor for 1-10 V/ 0–10 V lighting control systems, and as an open standard alternative to several proprietary protocols.