enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Toyota Tacoma - Wikipedia

   en.wikipedia.org/wiki/Toyota_Tacoma

   It is built on Toyota's TNGA-F global body-on-frame vehicle platform, shared with the larger Toyota Tundra (XK70). [83] The Tacoma was designed by teams at Toyota's Calty Design Research facilities in California and Michigan with the intention "to be authentic to the way our customers use their trucks for rugged outdoor fun", according to Calty ...

3. Bi-wiring - Wikipedia

   en.wikipedia.org/wiki/Bi-wiring

   Bi-wiring is a means of connecting a loudspeaker to an audio amplifier, primarily used in hi-fi systems. Normally, there is one pair of connectors on a loudspeaker and a single cable (two conductors) runs from the amplifier output to the terminals at the loudspeaker housing.

4. Speaker terminal - Wikipedia

   en.wikipedia.org/wiki/Speaker_terminal

   A speaker terminal is a type of electrical connector often used for interconnecting speakers and audio power amplifiers. The terminals are used in pairs with each of the speaker cable 's two wires being connected to one terminal in the pair.

5. Voice coil - Wikipedia

   en.wikipedia.org/wiki/Voice_coil

   Copper-clad aluminium wire is occasionally used, allowing easier winding, along with a useful reduction in coil mass compared to copper. Anodized aluminium flat wire may be used, providing an insulating oxide layer more resistant to dielectric breakdown than enamel coatings on other voice coil wire. This creates lightweight, low-inductance ...

6. Electrical connector - Wikipedia

   en.wikipedia.org/wiki/Electrical_connector

   Wires are typically attached to male or female blade connector terminals by either crimping or soldering. Insulated and uninsulated varieties are available. In some cases the blade is an integral manufactured part of a component (such as a switch or a speaker unit), and the reciprocal connector terminal is pushed onto the device's connector ...

7. Speaker wire - Wikipedia

   en.wikipedia.org/wiki/Speaker_wire

   Speaker wire is a passive electrical component described by its electrical impedance, Z.The impedance can be broken up into three properties which determine its performance: the real part of the impedance, or the resistance, and the imaginary component of the impedance: capacitance or inductance.

8. Speakon connector - Wikipedia

   en.wikipedia.org/wiki/Speakon_connector

   Speakon connectors arrange their contacts in two concentric rings, with the inner contacts named +1, +2, etc. and the outer contacts connectors (in the four-pole and eight-pole version only) named −1, −2, etc. [7] The phase convention is that positive voltage on the + contact causes air to be pushed away from the speaker.

9. Subwoofer - Wikipedia

   en.wikipedia.org/wiki/Subwoofer

   From about 1900 to the 1950s, the "lowest frequency in practical use" in recordings, broadcasting and music playback was 100 Hz. [9] When sound was developed for motion pictures, the basic RCA sound system was a single 8-inch (20 cm) speaker mounted in straight horn, an approach which was deemed unsatisfactory by Hollywood decisionmakers, who hired Western Electric engineers to develop a ...