Search results
Results from the WOW.Com Content Network
This pin is mounted within the piston: unlike the steam engine, there is no piston rod or crosshead (except big two stroke engines). The typical piston design is on the picture. This type of piston is widely used in car diesel engines. According to purpose, supercharging level and working conditions of engines the shape and proportions can be ...
A piston is a component of reciprocating engines. It is located in a cylinder and is made gas-tight by piston rings. Its purpose is to transfer force from expanding gas in the cylinder to the crankshaft via a piston rod and/or connecting rod. In two-stroke engines the piston also acts as a valve by covering and uncovering ports in the cylinder ...
This is a list of auto parts, which are manufactured components of automobiles. This list reflects both fossil-fueled cars (using internal combustion engines) and electric vehicles; the list is not exhaustive. Many of these parts are also used on other motor vehicles such as trucks and buses.
Ray-traced image of a piston engine. There may be one or more pistons. Each piston is inside a cylinder, into which a gas is introduced, either already under pressure (e.g. steam engine), or heated inside the cylinder either by ignition of a fuel air mixture (internal combustion engine) or by contact with a hot heat exchanger in the cylinder (Stirling engine).
The distance between the axis of the crankpins and the axis of the crankshaft determines the stroke length of the engine. [1] Most modern car engines are classified as "over square" or short-stroke, [citation needed] wherein the stroke is less than the diameter of the cylinder bore. A common way to increase the low-RPM torque of an engine is to ...
Reciprocating engine of a car Diesel generator for backup power. Reciprocating piston engines are by far the most common power source for land and water vehicles, including automobiles, motorcycles, ships and to a lesser extent, locomotives (some are electrical but most use diesel engines [16] [17]). Rotary engines of the Wankel design are used ...
Similar to U engines, H engines consist of two separate flat engines joined by gears or chains. H engines have been produced with between 4 and 24 cylinders. An opposed-piston engine is similar to a flat engine in that pairs of pistons are co-axial but rather than sharing a crankshaft, instead share a single combustion chamber per pair of ...
Cylinder liners (also known as sleeves) are thin metal cylinder-shaped parts which are inserted into the engine block to form the inner wall of the cylinder. [4] [5] Alternatively, an engine can be 'sleeveless', where the cylinder walls are formed by the engine block with a wear-resistant coating, such as Nikasil or plasma-sprayed bores.