enow.com Web Search

  1. Ads

    related to: dimmable lamp with dimmer circuit

Search results

  1. Results from the WOW.Com Content Network
  2. Dimmer - Wikipedia

    en.wikipedia.org/wiki/Dimmer

    This circuit is called a leading-edge dimmer or forward phase dimming. Waveform of the output voltage of a thyristor dimmer set for 60 volts RMS output, with 120 V input. The red trace shows the output device switching on about 5.5 ms after the input (blue) voltage crosses zero.

  3. LED lamp - Wikipedia

    en.wikipedia.org/wiki/LED_lamp

    LED emitters are inherently suitable for dimming, because they can operate over a wide range of currents without significant change of color. However, the circuits in LED lamps must be explicitly designed to be dimmable and compatible with particular types of dimmer switch. [105] Otherwise damage to the lamp and/or the dimmer may result.

  4. 0-10 V lighting control - Wikipedia

    en.wikipedia.org/wiki/0-10_V_lighting_control

    Dimming fluorescent ballasts and dimming LED drivers often use 0–10 V control signals to control dimming functions. In many cases, the dimming range of the power supply or ballast is limited. If the light output can only be dimmed from 100% down to 10%, there must be a switch or relay available to kill power to the system and turn the light ...

  5. Compact fluorescent lamp - Wikipedia

    en.wikipedia.org/wiki/Compact_fluorescent_lamp

    The dimmer switch used in conjunction with a dimmable CFL must be matched to its power consumption range; [58] many dimmers installed for use with incandescent bulbs do not function acceptably below 40 W, whereas CFL applications commonly draw power in the range 7–20 W. Dimmable CFLs have been marketed before suitable dimmers are available.

  6. Electrical ballast - Wikipedia

    en.wikipedia.org/wiki/Electrical_ballast

    A dimmable ballast is very similar to a rapid start ballast, except that the autotransformer is connected to a dimmer. A quadrac type light dimmer can be used with a dimming ballast, which maintains the heating current while allowing lamp current to be controlled. A resistor of about 10 kΩ is required to be connected in parallel with the ...

  7. Touch-sensitive lamp - Wikipedia

    en.wikipedia.org/wiki/Touch-sensitive_lamp

    Aladdin Industries filed key "Aladdin Lamps" patents in 1954 and 1956, [1] [2] and commercial models were available by 1955. [3] However, due to low electrical efficiency and high price of the vacuum tube-based product, the concept was not popularized until later versions of the touch mechanism used integrated circuits and transistors to improve efficiency and reduce cost in the mid 1980s.

  1. Ads

    related to: dimmable lamp with dimmer circuit