Ads
related to: 400 small block serpentine kit
Search results
Results from the WOW.Com Content Network
A 400 cu in (6.6 L) small-block V8 in a 1975 Avanti II. The 400.92 cu in (6,570 cc) 400 is the only engine in this family; it was introduced in 1970 and produced for ten years. It has a 4.125-inch (104.8 mm) bore and a 3.750-inch (95.25 mm) stroke.
Also called the GM small corporate pattern and the S10 pattern. This pattern has a distinctive odd-sided hexagonal shape. Rear wheel drive applications have the starter mounted on the right side of the block (when viewed from the flywheel) and on the opposite side of the block compared to front wheel drive installations.
The big-block engines initially used a forged crankshaft with a stroke of 3.975" for the 1965-1967 425 and 400 CID versions; starting in 1968, both the 400 cu in (6.6 L) and the 455 cu in (7.5 L) big blocks used a stroke of 4.25 in (108 mm), with crankshaft material changed to cast iron except in a few rare cases.
In the mid-1960s, Chrysler decided to adapt the 318 cu in (5.2 L) small block V8 into a lightweight, high output engine equally suited for drag strip or street performance use. Its block was bored out to 4.04 in (102.6 mm) but its 3.31 in (84.1 mm) stroke left unchanged, resulting in the 340 cu in (5.6 L) engine introduced for the 1968 model year.
The K5 Blazer was fitted with a 250 cu in (4.1 L) inline-six as standard through 1984. Available engines included a 292 cu in (4.8 L) inline-six, small-block V8s of 305, 307, 350, or 400 cubic inches (5.0, 5.0, 5.7, and 6.6 liters), and a 6.2 L Detroit Diesel V8. The six-cylinder Blazer was not recommended for towing. [11]
The 400 cu in (6.6 L) B engine was introduced in 1972 to replace the venerable 383, and were power-rated via the net (installed) method. Chrysler increased the bore size of the 383 to create the 400. Its bore of 4.342-inch (110.3 mm) was the largest used in any production Chrysler V8 at the date of its introduction.
Ads
related to: 400 small block serpentine kit