enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Wall stud - Wikipedia

   en.wikipedia.org/wiki/Wall_stud

   Wall studs are framing components in timber or steel-framed walls, that run between the top and bottom plates.It is a fundamental element in frame building. The majority non-masonry buildings rely on wall studs, with wood being the most common and least-expensive material used for studs.

3. Blocking (construction) - Wikipedia

   en.wikipedia.org/wiki/Blocking_(construction)

   When correctly placed, blocking also provides grounds (also backing or back blocking) for supporting the cut ends of wall claddings and linings or for attaching items such as cabinets, shelving, handrails, vanity tops and backsplashes, towel bars, decorative mouldings, etc. Properly placed grounds make the second fixings easier once the walls ...

4. Toenailing - Wikipedia

   en.wikipedia.org/wiki/Toenailing

   Example of toenailing in stud framing. Toenailing or skew-nailing is a viable, structurally sound method [1] of the driving of a nail at a roughly 30° [2] angle to fasten two pieces of wood together, typically with their grains perpendicular. The term comes colloquially from fastening wood at the bottom, or toe, of the board.

5. Framing (construction) - Wikipedia

   en.wikipedia.org/wiki/Framing_(construction)

   Wall framing in house construction includes the vertical and horizontal members of exterior walls and interior partitions, both of bearing walls and non-bearing walls. . These stick members, referred to as studs, wall plates and lintels (sometimes called headers), serve as a nailing base for all covering material and support the upper floor platforms, which provide the lateral strength along a

6. Nail (fastener) - Wikipedia

   en.wikipedia.org/wiki/Nail_(fastener)

   The broad end of the pin is slightly wider than the hole of the nail-header: the smith fits the pin into the hole of the nail-header and then hammers the broad end of the pin. Unable to advance through the hole, the broad end is flattened against the nail-header to create a nail-head.

7. Frame and panel - Wikipedia

   en.wikipedia.org/wiki/Frame_and_panel

   The panels are usually either flat or raised. A flat panel has its visible face flush with the front of the groove in the frame. This gives the panel an inset appearance. This style of panel is commonly made from man-made materials such as MDF or plywood but may also be made from solid wood or tongue and groove planks. Panels made from MDF will ...

8. Glossary of woodworking - Wikipedia

   en.wikipedia.org/wiki/Glossary_of_woodworking

   The frame or main parts of an unfinished workpiece before they are completed with coverings. card scraper A flat blade with a burred edge used for smoothing. carpentry caul A strip or block of wood used to distribute or direct clamping force. See batten. chainsaw chamfer chatoyance

9. Joinery - Wikipedia

   en.wikipedia.org/wiki/Joinery

   The end of a piece of wood is butted against another piece of wood. This is the simplest and weakest joint. Of those, there is the a) T-butt, b) end-to-end butt, c) Miter butt and d) edge-to-edge butt. Lap joint: The end of a piece of wood is laid over and connected to another piece of wood.