Search results
Results from the WOW.Com Content Network
direct TPM sensor fitted in valve system, manufacturer VDO. In most current designs of direct TPMS, a small electronic assembly which is rugged enough to be mounted inside a tire, measures the pressure using a microelectromechanical system (MEMS) [1] pressure sensor and then transmits this and other information to one or more vehicle receivers. [1]
Bicycle floor pump Foot-operated bike pump Frame-mounted bike pump Outdoor public air compressor for bicycles. A bicycle pump is a type of positive-displacement air pump specifically designed for inflating bicycle tires. It has a connection or adapter for use with one or both of the two most common types of valves used on bicycles, Schrader or ...
Additionally, fuel efficiency and tire wear are severely affected by under-inflation. Tires do not only leak air if punctured, they also leak air naturally, and over a year, even a typical new, properly mounted tire can lose from 20 to 60 kPa (3 to 9 psi), roughly 10% or even more of its initial pressure.
Inflating a bicycle tire equipped with a Presta or Dunlop valve at an automobile filling station requires an adaptor, while a Schrader-valved tube does not. Inflating at home or on the road requires either 6mm air chuck for Presta and Dunlop valves, or an 8mm chuck for Schrader valves. An important advantage of Schrader valves relative to ...
An inflator stem is not used; instead, a removable cap on a valve stem embedded in the tire rim is fitted, with only the cap visible. When inflating the tire, the cap is first removed, typically with a coin, and then a "portable" dedicated inflator stem is screwed onto the valve stem. Through the inflator, the tire is inflated as usual.
Inner tube: a bladder that contains air to inflate a tire. Has a Schrader, "Woods"/"Dunlop" or Presta valve for inflation and deflation; Jockey wheel or Pulley wheel: one of two small sprockets of the rear derailleur that guides the chain; Kickstand: a folding attachment used for assisting a bicycle to stand up on its own. Usually mounts to ...
A tire valve goes through a hole in the rim, and the hole slightly weakens the rim. Presta valves are thinner than Schrader valves, so can fit through a smaller hole. For bicycle rims which are narrow and lightweight (thus highly stressed), a smaller hole makes the rim and wheel stronger.
If the tire is not checked, it has the potential to cause vibration in the suspension of the vehicle on which it is mounted. In tire retail shops, tire/wheel assemblies are checked on a spin-balancer, which determines the amount and angle of unbalance. Balance weights are then fitted to the outer and inner flanges of the wheel. [2]