Search results
Results from the WOW.Com Content Network
In circuit theory, flux linkage is a property of a two-terminal element. It is an extension rather than an equivalent of magnetic flux and is defined as a time integral [citation needed] where is the voltage across the device, or the potential difference between the two terminals. This definition can also be written in differential form as a rate.
Fig. 1 L P σ and L S σ are primary and secondary leakage inductances expressed in terms of inductive coupling coefficient under open-circuited conditions.. The magnetic circuit's flux that does not interlink both windings is the leakage flux corresponding to primary leakage inductance L P σ and secondary leakage inductance L S σ.
Inductance is the tendency of an electrical conductor to oppose a change in the electric current flowing through it. The electric current produces a magnetic field around the conductor. The magnetic field strength depends on the magnitude of the electric current, and follows any changes in the magnitude of the current.
Magnetic flux. In physics, specifically electromagnetism, the magnetic flux through a surface is the surface integral of the normal component of the magnetic field B over that surface. It is usually denoted Φ or ΦB. The SI unit of magnetic flux is the weber (Wb; in derived units, volt–seconds), and the CGS unit is the maxwell [1].
A memristor (/ ˈ m ɛ m r ɪ s t ər /; a portmanteau of memory resistor) is a non-linear two-terminal electrical component relating electric charge and magnetic flux linkage.It was described and named in 1971 by Leon Chua, completing a theoretical quartet of fundamental electrical components which also comprises the resistor, capacitor and inductor.
One approach is to define the notion of "rate of change of flux linkage" by drawing a hypothetical line across the disc from the brush to the axle and asking how much flux linkage is swept past this line per unit time. See Figure 2. Assuming a radius R for the disc, a sector of disc with central angle θ has an area:
Direct torque control. Direct torque control (DTC) is one method used in variable-frequency drives to control the torque (and thus finally the speed) of three-phase AC electric motors. This involves calculating an estimate of the motor's magnetic flux and torque based on the measured voltage and current of the motor.
Electromagnetic induction. Alternating electric current flows through the solenoid on the left, producing a changing magnetic field. This field causes, by electromagnetic induction, an electric current to flow in the wire loop on the right. Electromagnetic or magnetic induction is the production of an electromotive force (emf) across an ...