enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. NEMA connector - Wikipedia

   en.wikipedia.org/wiki/NEMA_connector

   The addition is a 3 ⁄ 16-inch (4.8 mm) diameter round or U-shaped ground pin, 1 ⁄ 8 in (3.2 mm) longer than the power blades (so the device is grounded before the power is connected) and located from them by 1 ⁄ 4 in (6.4 mm) edge-to-edge or 15 ⁄ 32 in (11.9 mm) center-to-center.

3. Electrical wiring in North America - Wikipedia

   en.wikipedia.org/wiki/Electrical_wiring_in_North...

   In both those instances the white wire should be identified as being hot, usually with black tape inside junction boxes. The neutral wire is identified by gray or white insulated wire, perhaps using stripes or markings. With lamp cord wire the ribbed wire is the neutral, and the smooth wire is the hot. NEC 2008 400.22(f) allows surface marking ...

4. Split-phase electric power - Wikipedia

   en.wikipedia.org/wiki/Split-phase_electric_power

   Single-pole circuit breakers feed 120 V circuits from one of the 120 V buses within the panel, or two-pole circuit breakers feed 240-volt circuits from both buses. 120 V circuits are the most common, and used to power NEMA 1 and NEMA 5 outlets, and most residential and light commercial direct-wired lighting circuits.

5. DIN 72552 - Wikipedia

   en.wikipedia.org/wiki/DIN_72552

   3. slow rpm 33h 4. slow rpm 33L rotation left 30L 33R rotation right 30R Indicators 49 flasher unit in 15, 15+, 15/54, +, +15, X 49a flasher unit out, indicator switch in 54L, S, S4, L 49b out 2. flasher circuit 49c out 3. flasher circuit C 1st flasher indicator light K, K1, P C2 2nd flasher indicator light K1, K2, K3, K4 C3

6. IEC 60228 - Wikipedia

   en.wikipedia.org/wiki/IEC_60228

   Comparison of SWG (red), AWG (blue) and IEC 60228 (black) wire gauge sizes from 0.03 to 200 mm² to scale on a 1 mm grid – in the SVG file, hover over a size to highlight it. In engineering applications, it is often most convenient to describe a wire in terms of its cross-section area, rather than its diameter, because the cross section is directly proportional to its strength and weight ...

7. High-leg delta - Wikipedia

   en.wikipedia.org/wiki/High-leg_delta

   Even when unmarked, it is generally easy to identify this type of system, because the B phase (circuits #3 and #4) and every third circuit afterwards will be either a three-pole breaker or a blank. Current practice is to give separate services for single-phase and three-phase loads, e.g., 120 V split-phase (lighting etc.) and 240 V to 600 V ...