enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Circlip - Wikipedia

   en.wikipedia.org/wiki/Circlip

   E-clip. Common examples include e-clips (e-rings) and the snap ring (both internal and external) or circlip. These general types of fasteners are sized to provide an interference fit onto (or into, in the case of an internal fastener) a groove or land when in use, such that they must be elastically deformed in order to install or remove them.

3. British Standard Fine - Wikipedia

   en.wikipedia.org/wiki/British_Standard_Fine

   British Standard Fine (BSF) is a screw thread form, as a fine-pitch alternative to British Standard Whitworth (BSW) thread. It was used for steel bolts and nuts on and in much of Britain's machinery, including cars, prior to adoption of Unified, and later Metric, standards.

4. R-clip - Wikipedia

   en.wikipedia.org/wiki/R-clip

   An R-clip, also known as an R-pin, R-key, hairpin cotter pin, [1] hairpin cotter, [2] bridge pin, [2] hitch pin clip [3] [4] or spring cotter pin, [5] is a fastener made of a durable but flexible material, commonly hardened metal wire, resembling the shape of the letter "R".

5. Nut (hardware) - Wikipedia

   en.wikipedia.org/wiki/Nut_(hardware)

   Caged nut, captive nut, clip nut A (usually square) nut in a spring steel cage which wraps around the nut. The cage has two wings that when compressed allow the cage to be inserted into the square holes Clip-on nut: J-nut or U-nut, sheet metal nut, speed nut (ambiguously) Designed to be clipped to sheet metal Coupling nut: Extension nut

6. ISO metric screw thread - Wikipedia

   en.wikipedia.org/wiki/ISO_metric_screw_thread

   A metric ISO screw thread is designated by the letter M followed by the value of the nominal diameter D (the maximum thread diameter) and the pitch P, both expressed in millimetres and separated by a dash or sometimes the multiplication sign, × (e.g. M8-1.25 or M8×1.25).

7. Unified Thread Standard - Wikipedia

   en.wikipedia.org/wiki/Unified_Thread_Standard

   The number series of machine screws has been extended downward to include #00-90 (0.047 in = 0.060 in − 0.013 in) and #000-120 (0.034 in = 0.060 in − 2 × 0.013 in) screws; [3] however, the main standard for screws smaller than #0 is ANSI/ASME standard B1.10 Unified Miniature Screw Threads. This defines a series of metric screws named after ...