Search results
Results from the WOW.Com Content Network
The silicon-based RF LDMOS (radio-frequency LDMOS) is the most widely used RF power amplifier in mobile networks, [2] [3] [4] enabling the majority of the world's cellular voice and data traffic. [5] LDMOS devices are widely used in RF power amplifiers for base-stations as the requirement is for high output power with a corresponding drain to ...
The first discrete-transistor audio amplifiers barely supplied a few hundred milliwatts, but power and audio fidelity gradually increased as better transistors became available and amplifier architecture evolved. [94] Modern transistor audio amplifiers of up to a few hundred watts are common and relatively inexpensive.
In electronics, the metal–oxide–semiconductor field-effect transistor (MOSFET, MOS-FET, MOS FET, or MOS transistor) is a type of field-effect transistor (FET), most commonly fabricated by the controlled oxidation of silicon. It has an insulated gate, the voltage of which determines the conductivity of the device.
Amplifiers operate in the active region, where both device current and voltage are non-zero. Consequently power is continually dissipated and its design is dominated by the need to remove excess heat from the semiconductor device. Power amplifier devices can often be recognized by the heat sink used to mount the devices. Multiple types of power ...
The most common type of FET amplifier is the MOSFET amplifier, which uses metal–oxide–semiconductor FETs (MOSFETs). The main advantage of a FET used for amplification is that it has very high input impedance and low output impedance .
The input signal is applied across the ground and the base circuit of the transistor. The output signal appears across ground and the collector of the transistor. Since the emitter is connected to the ground, it is common to signals, input and output. The common-emitter circuit is the most widely used of junction transistor amplifiers.
Bio-FETs couple a transistor device with a bio-sensitive layer that can specifically detect bio-molecules such as nucleic acids and proteins. A Bio-FET system consists of a semiconducting field-effect transistor that acts as a transducer separated by an insulator layer (e.g. SiO 2) from the biological recognition element (e.g. receptors or probe molecules) which are selective to the target ...
In a single-stage amplifier, one can increase channel length to get higher output resistance and gain as well, but this also increases the parasitic capacitance of transistors, which limits the amplifier bandwidth. The transistor channel length is smaller in modern CMOS technologies, which makes achieving high gain in single-stage amplifiers ...