Search results
Results from the WOW.Com Content Network
In computer systems programming, an interrupt handler, also known as an interrupt service routine or ISR, is a special block of code associated with a specific interrupt condition. Interrupt handlers are initiated by hardware interrupts, software interrupt instructions, or software exceptions , and are used for implementing device drivers or ...
An interrupt vector table (IVT) is a data structure that associates a list of interrupt handlers with a list of interrupt requests in a table of interrupt vectors. Each entry of the interrupt vector table, called an interrupt vector, is the address of an interrupt handler (also known as ISR). While the concept is common across processor ...
A hardware interrupt is a condition related to the state of the hardware that may be signaled by an external hardware device, e.g., an interrupt request (IRQ) line on a PC, or detected by devices embedded in processor logic (e.g., the CPU timer in IBM System/370), to communicate that the device needs attention from the operating system (OS) [7] or, if there is no OS, from the bare metal ...
Diagram about the course of an interrupt routine. In a computer, an interrupt request (or IRQ) is a hardware signal sent to the processor that temporarily stops a running program and allows a special program, an interrupt handler, to run instead.
The typical method of using an interrupt vector involves reading its present value (the address), storing it within the memory space of the TSR, and replacing it with an address in its own code. The stored address is called from the TSR, in effect forming a singly linked list of interrupt handlers, also called interrupt service routines, or
In computer science, a vectored interrupt is a processing technique in which the interrupting device directs the processor to the appropriate interrupt service routine. This is in contrast to a polled interrupt system, in which a single interrupt service routine must determine the source of the interrupt by checking all potential interrupt ...
A reentrant interrupt handler is an interrupt handler that re-enables interrupts early in the interrupt handler. This may reduce interrupt latency. [6] In general, while programming interrupt service routines, it is recommended to re-enable interrupts as soon as possible in the interrupt handler. This practice helps to avoid losing interrupts. [7]
A well-designed and succinct interrupt handler or interrupt service routine (ISR) will not only expeditiously service any event that causes an interrupt, it will do so without interfering in any way with the interrupted foreground task—the ISR must be "transparent" to the interrupted task (although exceptions may apply in specialized cases ...