Search results
Results from the WOW.Com Content Network
A prescaler is an electronic counting circuit used to reduce a high frequency electrical signal to a lower frequency by integer division.The prescaler takes the basic timer clock frequency (which may be the CPU clock frequency or may be some higher or lower frequency) and divides it by some value before feeding it to the timer, according to how the prescaler register(s) are configured.
The 8052 was an enhanced version of the original 8051 that featured 256 bytes of internal RAM instead of 128 bytes, 8 KB of ROM instead of 4 KB, and a third 16-bit timer. Most modern 8051-compatible microcontrollers include these features. The 8032 had these same features as the 8052 except it lacked internal ROM program memory.
MCU 8051 IDE has a built-in simulator not only for the MCU itself, but also LCD displays and simple LED outputs as well as button inputs. It supports two programming languages: C (using SDCC ) and assembly and runs on both Windows and Unix -based operating systems, such as FreeBSD and Linux .
Delay calculation is the term used in integrated circuit design for the calculation of the gate delay of a single logic gate and the wires attached to it. By contrast, static timing analysis computes the delays of entire paths, using delay calculation to determine the delay of each gate and wire.
An AT89c2051 microcontroller in circuit. The Atmel AT89 series is an Intel 8051-compatible family of 8 bit microcontrollers (μCs) manufactured by the Atmel Corporation.. Based on the Intel 8051 core, the AT89 series remains very popular as general purpose microcontrollers, due to their industry standard instruction set, their low unit cost, and the availability of these chips in DIL (DIP ...
The dual-slope conversion can take a long time: a thousand or so clock ticks in the scheme described above. That limits how often a measurement can be made (dead time). Resolution of 1 ps with a 100 MHz (10 ns) clock requires a stretch ratio of 10,000 and implies a conversion time of 150 μs. [13]
On 5 January 1975, the 12-bit field that had been used for dates in the TOPS-10 operating system for DEC PDP-10 computers overflowed, in a bug known as "DATE75". The field value was calculated by taking the number of years since 1964, multiplying by 12, adding the number of months since January, multiplying by 31, and adding the number of days since the start of the month; putting 2 12 − 1 ...
Most predetermined motion time systems (MTM and MOST) use time measurement units (TMU) instead of seconds for measuring time. One TMU is defined to be 0.00001 hours, or 0.036 seconds according to MTM100 and 0.0000083 hours, or 0.030 seconds according to BS100. [1] These smaller units allow for more accurate calculations without the use of decimals.