Search results
Results from the WOW.Com Content Network
Gas is breathed at ambient pressure, and some of this gas dissolves into the blood and other fluids. Inert gas continues to be taken up until the gas dissolved in the tissues is in a state of equilibrium with the gas in the lungs (see saturation diving), or the ambient pressure is reduced until the inert gases dissolved in the tissues are at a higher concentration than the equilibrium state ...
[20] [21] Tissue compartment half times used in decompression modelling range from 1 minute to at least 720 minutes. [22] For example: A 5 minute tissue will be 50% saturated in 5 minutes, 75% in 10 minutes, 87.5% in 15 minutes and for practical purposes, saturated in about 30 minutes (98.44% saturated at 6 half times)
Decompression profiles based on the Thermodynamic model compared with the US Navy table for the same depth and bottom time. The thermodynamic model was one of the first decompression models in which decompression is controlled by the volume of gas bubbles coming out of solution. In this model, pain only DCS is modelled by a single tissue which ...
The main feature of thermodynamic diagrams is the equivalence between the area in the diagram and energy. When air changes pressure and temperature during a process and prescribes a closed curve within the diagram the area enclosed by this curve is proportional to the energy which has been gained or released by the air.
At stage 1 retrograde metamorphism, near-isothermal decompression after the peak, which indicates uplift and exhumation of the compressed rock in the orogenic belt or forearc. [ 16 ] At stage 2 retrograde metamorphism, further decompression and cooling occur at a slow rate, implying further erosion after the tectonic event.
Partial melting is the phenomenon that occurs when a rock is subjected to temperatures high enough to cause certain minerals to melt, but not all of them. Partial melting is an important part of the formation of all igneous rocks and some metamorphic rocks (e.g., migmatites), as evidenced by a multitude of geochemical, geophysical and petrological studies.
Decompression melting occurs because of a decrease in pressure. [40] The solidus temperatures of most rocks (the temperatures below which they are completely solid) increase with increasing pressure in the absence of water. Peridotite at depth in the Earth's mantle may be hotter than its solidus temperature at some shallower level.
The model assumptions are: the uncompressed volume of the cylinder is one litre (1 L = 1000 cm 3 = 0.001 m 3); the gas within is the air consisting of molecular nitrogen and oxygen only (thus a diatomic gas with 5 degrees of freedom, and so γ = 7 / 5 ); the compression ratio of the engine is 10:1 (that is, the 1 L volume of uncompressed ...