Search results
Results from the WOW.Com Content Network
Since Windows Server 2012, it is enabled by default in Windows Server versions, because Data Center Transmission Control Protocol (DCTCP) is used. [12] In previous Windows versions and non-server versions it is disabled by default. ECN support can be enabled using a shell command such as netsh interface tcp set global ecncapability=enabled.
In computing, netsh, or network shell, is a command-line utility included in Microsoft's Windows NT line of operating systems beginning with Windows 2000. [1] It allows local or remote configuration of network devices such as the interface .
The Neighbor Discovery Protocol (NDP), or simply Neighbor Discovery (ND), is a protocol of the Internet protocol suite used with Internet Protocol Version 6 (IPv6). [1]: §1 It operates at the internet layer of the Internet model, [2] and is responsible for gathering various information required for network communication, including the configuration of local connections and the domain name ...
For this reason, ECN is disabled by default. It can be enabled via the netsh interface tcp set global ecncapability=enabled command. [3] In previous versions of Windows, all processing needed to receive or transfer data over one network interface was done by a single processor, even in a multi processor system.
An ARP probe in IPv4 is an ARP request constructed with the SHA of the probing host, an SPA of all 0s, a THA of all 0s, and a TPA set to the IPv4 address being probed for. If some host on the network regards the IPv4 address (in the TPA) as its own, it will reply to the probe (via the SHA of the probing host) thus informing the probing host of ...
Link-local addresses may be assigned manually by an administrator or by automatic operating system procedures. In Internet Protocol (IP) networks, they are assigned most often using stateless address autoconfiguration, a process that often uses a stochastic process to select the value of link-local addresses, assigning a pseudo-random address that is different for each session.
The configuration software of choice is then used to configure the persistent configuration which is applied on boot. It is also possible to configure Linux networking ad-hoc using the ip command from the iproute2 package. The following command can be used to configure the route using ip: [10]
In the typical case of a home network, for example, the home router uses DHCPv6 to request a network prefix from the ISP's DHCPv6 server. Once assigned, the ISP routes this network to the customer's home router and the home router starts advertising the new address space to hosts on the network, either via SLAAC or using DHCPv6.