enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Hex key - Wikipedia

   en.wikipedia.org/wiki/Hex_key

   A hex key (also, hex wrench, Allen key and Allen wrench or Inbus) is a simple driver for bolts or screws that have heads with internal hexagonal recesses ().. Hex keys are formed from a single piece of hard hexagonal steel rod, having blunt ends that fit snugly into similarly shaped screw sockets.

3. Wrench size - Wikipedia

   en.wikipedia.org/wiki/Wrench_size

   spanner (wrench) size and thread diameter of a hex nut. Width across flats is the distance between two parallel surfaces on the head of a screw or bolt, or a nut, mostly for torque transmission by positive locking. The term width across flats (AF) is used for the following forms: 2-socket = round material with two surfaces

4. List of screw drives - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_drives

   A hex screw drive uses six-sided fastener heads, and the fastener is known as a hex head cap screw. It can be turned with an adjustable wrench, combination wrench and 6- or 12-point sockets. The hex drive is better than square drive for locations where surrounding obstacles limit wrenching access, because smaller wrench-swing arcs can still ...

5. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   An ASME B18.2.1 compliant cap screw has somewhat tighter tolerances than a hex bolt for the head height and the shank length. The nature of the tolerance difference allows an ASME B18.2.1 hex cap screw to always fit where a hex bolt is installed but a hex bolt could be slightly too large to be used where a hex cap screw is designed in.

6. Remove Stubborn Nuts and Bolts With These Editor-Approved ...

   www.aol.com/lifestyle/best-adjustable-wrenches...

   For premium support please call: 800-290-4726 more ways to reach us

7. Nut driver - Wikipedia

   en.wikipedia.org/wiki/Nut_driver

   A spinner handle is a shaft and handle with a drive fitting—most commonly 1 ⁄ 4 in (6.35 mm) square axle at the end for attaching interchangeable sockets. This allows one to use a single handle with a number of sizes instead of having a separate nut driver for each size.