Search results
Results from the WOW.Com Content Network
For the wide-ratio transmission, the first gear ratio is 4:1 or 4, and in second gear it is 2:1 or 2, so the progression is equal to 4 / 2 = 2 (or 200%). For the close-ratio transmission, first gear has a 4:1 ratio or 4, and second gear has a ratio of 3:1 or 3, so the progression between gears is 4 / 3 , or 133%. Since 133% is ...
Here, the ratio is − + 27 / 18 , or − + 3 / 2 ; meaning that each planet gear turns at 3 / 2 the rate of the sun gear, in the opposite direction. An outer ring gear is not shown.
The opposite effect is obtained when a large gear drives a small one. The changes are proportional to the gear ratio r, the ratio of the tooth counts: namely, T 2 / T 1 = r = N 2 / N 1 , and ω 2 / ω 1 = 1 / r = N 1 / N 2 . Depending on the geometry of the pair, the sense of rotation may also be inverted ...
The gear range is difference between the highest and lowest gear ratios and may be expressed as a percentage (e.g., 500%) or as a ratio (e.g., 5:1). Heel [ edit ]
Thus the rotation action of the wave generator results in a much slower rotation of the flex spline in the opposite direction. For a strain wave gearing mechanism, the gearing reduction ratio can be calculated from the number of teeth on each gear, in a similar manner to a cycloidal drive:
The magnetic gear is a magnetic coupling device that renders a mechanical ratio between two magnetically-coupled devices such that: They have a ratio of rotation or translational movement between input and output which may be unity in the case of a pure magnetic coupling or one of many gear ratios in a magnetic gearbox.
For one cycle, they rotate 1/2, 1/4, and 1/12 of a revolution. . The 1/2-turn shaft carries (for each column) gears with 12, 14, 16, and 18 teeth, corresponding to digits 6, 7, 8, and 9. The 1/4-turn shaft carries (also, each column) gears with 12, 16, and 20 teeth, for 3, 4, and 5. Digits [1] and [2] are handled by 12 and 24-tooth gears on the ...
Typical gear ratios on bicycles range from very low or light gearing around 20 gear inches (1.6 metres per revolution), via medium gearing around 70 gear inches (5.6 m), to very high or heavy gearing around 125 gear inches (10 m). As in a car, low gearing is for going up hills and high gearing is for going fast.