Search results
Results from the WOW.Com Content Network
Drag coefficients in fluids with Reynolds number approximately 10 4 [1] [2] Shapes are depicted with the same projected frontal area. In fluid dynamics, the drag coefficient (commonly denoted as: , or ) is a dimensionless quantity that is used to quantify the drag or resistance of an object in a fluid environment, such as air or water.
Parasitic drag, or profile drag, is the sum of viscous pressure drag (form drag) and drag due to surface roughness (skin friction drag). Additionally, the presence of multiple bodies in relative proximity may incur so called interference drag , which is sometimes described as a component of parasitic drag.
This trend of increase in wave-making resistance continues up to a Froude number of ~0.45 (speed/length ratio ~1.50), and peaks at a Froude number of ~0.50 (speed/length ratio ~1.70). This very sharp rise in resistance at speed/length ratio around 1.3 to 1.5 probably seemed insurmountable in early sailing ships and so became an apparent barrier.
The drag equation may be derived to within a multiplicative constant by the method of dimensional analysis. If a moving fluid meets an object, it exerts a force on the object. Suppose that the fluid is a liquid, and the variables involved – under some conditions – are the: speed u, fluid density ρ, kinematic viscosity ν of the fluid,
Lowering the drag coefficient comes from streamlining the exterior body of the vehicle. Streamlining the body requires assumptions about the surrounding airspeed and characteristic use of the vehicle. Cars that try to reduce drag employ devices such as spoilers, wings, diffusers, and fins to reduce drag and increase speed in one direction. [4]
For any given value of lift, the AoA varies with speed. Graphs of C L and C D vs. speed are referred to as drag curves. Speed is shown increasing from left to right. The lift/drag ratio is given by the slope from the origin to some point on the curve and so the maximum L/D ratio does not occur at the point of least drag coefficient, the ...
If correctly selected, it reaches terminal velocity, which can be measured by the time it takes to pass two marks on the tube. Electronic sensing can be used for opaque fluids. Knowing the terminal velocity, the size and density of the sphere, and the density of the liquid, Stokes' law can be used to calculate the viscosity of the fluid. A ...
The low speed region shows a fall in lift induced drag, through a minimum followed by an increase in profile drag at higher speeds. The minimum power required, at a speed of 195 km/h (121 mph) is about 86 kW (115 hp); 135 kW (181 hp) is required for a maximum speed of 300 km/h (186 mph).