enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. 10 Reasons Why Your Toilet Won’t Stop Clogging - AOL

   www.aol.com/10-reasons-why-toilet-won-172100092.html

   If the water supply line valve is not fully open, not enough water will be in the bowl for effective flushing. The fill valve, found in the toilet water tank, can also cause problems.

3. 5 Easy Ways To Unclog A Toilet Without A Plunger - AOL

   www.aol.com/5-easy-ways-unclog-toilet-210000736.html

   Hot water can be an effective way to unclog a toilet since the scorching water loosen whatever is stuck in your pipes. "Using hot water is one of the go-to methods for clearing clogs, but be ...

4. Flush toilet - Wikipedia

   en.wikipedia.org/wiki/Flush_toilet

   After flushing, the flapper valve in the water tank closes or the flush valve shuts; water lines and valves connected to the water supply refill the toilet tank and bowl. Then the toilet is again ready for use. If the forward ("flush") jet connection to the upper inlet in the toilet clogs, poor or no flushing action may result. [citation needed]

5. 5 Signs It's Time To Replace Your Toilet, According To ... - AOL

   www.aol.com/5-signs-time-replace-toilet...

   A well-running toilet is essential to a bathroom that's clean, useful, and odor-free. But toilets aren't invincible. Like other parts of the home, toilets need intermittent repairs, especially to ...

6. Flushometer - Wikipedia

   en.wikipedia.org/wiki/Flushometer

   A flush occurs while it is in its open mid positions. Because the water is gradually shut off, slower water at the end of the cycle that will not activate the siphon serves to refill the bowl. The valve cannot be kept open by holding the flush lever in the activated position, wasting water, because this only sends the main cylinder valve all ...

7. Ballcock - Wikipedia

   en.wikipedia.org/wiki/Ballcock

   When the handle of a flush toilet with a tank (British, cistern) is turned, a discharge mechanism is activated by means of a rod or chain. The mechanism may be a flapper valve, which is designed to sink more slowly than the water - allowing the water to exit to the toilet bowl below, so that the tank may empty.