enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Cable gland - Wikipedia

   en.wikipedia.org/wiki/Cable_gland

   Shrouded cable glands going into a flow meter. Split cable gland KVT for routing pre-terminated cables. A cable gland (more often known in the U.S. as a cord grip, cable strain relief, cable connector or cable fitting) is a device designed to attach and secure the end of an electrical cable to the equipment. [1]

3. Cable management - Wikipedia

   en.wikipedia.org/wiki/Cable_management

   Usually, the lines are fixed by clamping them into single cable clamps made of plastic or metal. Another possibility is to use so called cord grips which consist of weaved wire strands that put a grip around the cables. [3] A more cable-friendly alternative is attaching the lines to special strain relief plates using common cable ties. In case ...

4. Underwriter's knot - Wikipedia

   en.wikipedia.org/wiki/Underwriter's_knot

   Underwriter's knot; Names: Underwriter's knot, Two-strand wall knot: Category: Stopper: Related: wall knot, crown knot: Typical use: electrical: Caveat: Note that the colors in this depiction do not match current practises in either the UK or the US, nor is this cable in keeping with current safety standards for electrical installations

5. Towing sock - Wikipedia

   en.wikipedia.org/wiki/Towing_sock

   A towing sock or wire rope puller or wire pulling grip is a device that connects to the end of a cable, such as a power cable, in order to pull it through a tube or tunnel. [1] It works by tightening around the cable when pulled, in the same manner as a Chinese finger trap . [ 2 ]

6. BNC connector - Wikipedia

   en.wikipedia.org/wiki/BNC_connector

   The BNC connector (initialism of "Bayonet Neill–Concelman") is a miniature quick connect/disconnect radio frequency connector used for coaxial cable. It is designed to maintain the same characteristic impedance of the cable, with 50 ohm and 75 ohm types being made. It is usually applied for video and radio frequency connections up to about 2 ...

7. List of RF connector types - Wikipedia

   en.wikipedia.org/wiki/List_of_RF_connector_types

   A double DIN 1.6/5.6 bulkhead jack connector, crimp type, for 75 Ω coaxial cable A Type N connector (male), right-angled solder-type for semi-rigid coaxial cable with a diameter of 0.141-inch. 4.1-9.5 connector, standardized as DIN 47231 (in 1974) and IEC 60169-11 (in 1977) 4.3-10 connector, formerly known as DIN 4.3/10, now standardized as ...