Search results
Results from the WOW.Com Content Network
An 'Access Point Name' (APN) is the name of a gateway [2] between a mobile network (GSM, GPRS, 3G, 4G and 5G) and another computer network, frequently the public Internet. [3] Some Important APN Terms: Below are some terms of the APN settings, explaining what each setting stands for: APN: The APN address of your (mobile network operator) MNOs.
GPRS Tunnelling Protocol is the defining IP-based protocol of the GPRS core network. Primarily it is the protocol which allows end users of a GSM or WCDMA network to move from place to place while continuing to connect to the Internet as if from one location at the Gateway GPRS support node (GGSN).
Mobile IP (or MIP) is an Internet Engineering Task Force (IETF) standard communications protocol that is designed to allow mobile device users to move from one network to another while maintaining a permanent IP address. Mobile IP for IPv4 is described in RFC 5944, and extensions are defined in RFC 4721. Mobile IPv6, the IP mobility ...
Cellular network standards and generation timeline. This is a comparison of standards of wireless networking technologies for devices such as mobile phones.A new generation of cellular standards has appeared approximately every tenth year since 1G systems were introduced in 1979 and the early to mid-1980s.
The Radio Resource Control (RRC) protocol is used in UMTS, LTE and 5G on the Air interface. It is a layer 3 (Network Layer) protocol used between UE and Base Station. This protocol is specified by 3GPP in TS 25.331 [2] for UMTS, in TS 36.331 [3] for LTE and in TS 38.331 [4] for 5G New Radio. RRC messages are transported via the PDCP-Protocol.
Later 3G releases, often denoted 3.5G and 3.75G, also provide mobile broadband access of several Mbit/s to smartphones and mobile modems in laptop computers. This ensures it can be applied to wireless voice telephony, mobile Internet access, fixed wireless Internet access, video calls and mobile TV technologies.
The maximum speed of a GPRS connection offered in 2003 was similar to a modem connection in an analog wire telephone network, about 32–40 kbit/s, depending on the phone used. Latency is very high; round-trip time (RTT) is typically about 600–700 ms and often reaches 1s. GPRS is typically prioritized lower than speech, and thus the quality ...
GPRS Tunnelling Protocol (GTP) is a group of IP-based communications protocols used to carry general packet radio service (GPRS) within GSM, UMTS, LTE and 5G NR radio networks. In 3GPP architectures, GTP and Proxy Mobile IPv6 based interfaces are specified on various interface points.