Search results
Results from the WOW.Com Content Network
A typical helicopter has three flight control inputs: the cyclic stick, the collective lever, and the anti-torque pedals. [2] Depending on the complexity of the helicopter, the cyclic and collective may be linked together by a mixing unit , a mechanical or hydraulic device that combines the inputs from both and then sends along the "mixed ...
Cyclic/collective pitch mixing (CCPM) is a control concept employed in collective pitch radio-controlled helicopters. [1] CCPM reduces mechanical complexity and increases precision of control of the helicopter rotor's swashplate. Unlike conventional systems in which a single actuator is responsible for a single axis, CCPM mechanisms allow ...
Static Rollover is a rolling action when the helicopter blades are not in rotation. When the rotor blades stop, the helicopter has the same principles of any other object and will roll if the static rollover critical angle is exceeded. Each helicopter has its own critical angle; this is a byproduct of its center-of-gravity.
The signs of VRS are a vibration in the main rotor system [8] followed by an increasing sink rate and possibly a decrease of cyclic authority. [9]In single rotor helicopters, the vortex ring state is traditionally corrected by slightly lowering the collective to regain cyclic authority and using the cyclic control to apply lateral motion, often pitching the nose down to establish forward flight.
A helicopter's main rotor hub. The vertical rods are at the end of the control chain that starts with the pilot controls. Helicopter flight controls are connected to the main and tail rotors, and include a cyclic stick, broadly to control forward-aft and left-right movements, a collective lever, broadly to control vertical movements, and anti-torque pedals, to control left and right yaw.
A helicopter has four flight control inputs. These are the cyclic, the collective, the anti-torque pedals, and the throttle. The cyclic control is usually located between the pilot's legs and is commonly called the cyclic stick or just cyclic. On most helicopters, the cyclic is similar to a joystick.
The cyclic and collective control the main rotor pitch through push-pull tube linkages to the swashplate, while the anti-torque pedals change the pitch of the tail rotor via a tensioned cable arrangement. Some UH-1Hs have been modified to replace the tail rotor control cables with push-pull tubes similar to the UH-1N Twin Huey. [24]
In aeronautics, a swashplate is a mechanical device that translates input via the helicopter flight controls into motion of the main rotor blades. Because the main rotor blades are spinning, the swashplate is used to transmit three of the pilot's commands from the non-rotating fuselage to the rotating rotor hub and mainblades.