enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Spring pin - Wikipedia

   en.wikipedia.org/wiki/Spring_pin

   A spring pin (also called tension pin or roll pin) is a mechanical fastener that secures the position of two or more parts of a machine relative to each other. Spring pins have a body diameter which is larger than the diameter of the hole they are intended for, and a chamfer on either one or both ends to facilitate starting the pin into the hole.

3. Punch (tool) - Wikipedia

   en.wikipedia.org/wiki/Punch_(tool)

   Roll pin punches are designed with a small projection in the center of the pin tip to support the circumference of the roll pin. The tips of roll pin punches are not flat and should never be used on regular solid pins. If a roll pin punch is used on a solid pin, it will mar or mark the pin. If the end of a roll pin punch is damaged or deformed ...

4. Harbor Freight Tools - Wikipedia

   en.wikipedia.org/wiki/Harbor_Freight_Tools

   Harbor Freight Tools won a declassification of the class action; that is, the court found that all the individual situations were not similar enough to be judged as a single class, and that their claims would require an individual-by-individual inquiry, so the case could not be handled on a class basis.

5. List of tool manufacturers - Wikipedia

   en.wikipedia.org/wiki/List_of_tool_manufacturers

   Snap-on, Bahco, Blue-Point, Williams, CDI Torque Products, [27] Sun diagnostic tools in Europe and Brazil: Hand tools, air tools, power tools, diagnostic tools, assorted automotive tools Sortimo: Zusmarshausen, Germany: Sortimo: in-vehicle equipment, storage system for parts and tools Stanley Black & Decker: Connecticut, US

6. Chuck (engineering) - Wikipedia

   en.wikipedia.org/wiki/Chuck_(engineering)

   Two pin chucks. The top one is assembled, the lower one shows the body and nose cap assembled with the collet piece below it. A drill chuck is a specialised self-centering, three-jaw chuck, usually with capacity of 0.5 in (13 mm) or less, and rarely greater than 1 in (25 mm), used to hold drill bits or other rotary tools. This type of chuck is ...

7. Drill bit - Wikipedia

   en.wikipedia.org/wiki/Drill_bit

   The correct tool to start a traditionally drilled hole (a hole drilled by a high-speed steel (HSS) twist drill bit) is a spotting drill bit (or a spot drill bit, as they are referenced in the U.S.). The included angle of the spotting drill bit should be the same as, or greater than, the conventional drill bit so that the drill bit will then ...