Search results
Results from the WOW.Com Content Network
The performance of an echo canceller is measured in echo return loss enhancement (ERLE), [3] [9] which is the amount of additional signal loss applied by the echo canceller. Most echo cancellers are able to apply 18 to 35 dB ERLE. The total signal loss of the echo (ACOM) is the sum of the ERL and ERLE. [9] [10]
Adaptive feedback cancellation originated during the evolution of the hearing aid. The hearing aid became digital, and as such feedback cancellation was needed. In 1980 a directional microphone was introduced in the digital hearing aid, and adaptive feedback cancellation was created to block external noise that the microphone picked up. Today ...
any real, finite, level of XPD instead manifests itself as a partial recombination between the two signals, so that the receivers observe an interference due to the cross-polarization leakage. Some of the factors causing such cross-polarization interference are listed in Polarization-Division Multiplexing. Polarization-Division Communication System
Long-latency connections also benefit; in the case of satellites orbiting distant planets, retransmission due to errors would create a delay of several hours. FEC is also widely used in modems and in cellular networks. FEC processing in a receiver may be applied to a digital bit stream or in the demodulation of a digitally modulated carrier.
The recording of a heart beat (an ECG), may be corrupted by noise from the AC mains.The exact frequency of the power and its harmonics may vary from moment to moment.. One way to remove the noise is to filter the signal with a notch filter at the mains frequency and its vicinity, but this could excessively degrade the quality of the ECG since the heart beat would also likely have frequency ...
A noise-cancellation speaker emits a sound wave with the same amplitude but with an inverted phase (also known as antiphase) relative to the original sound. The waves combine to form a new wave, in a process called interference , and effectively cancel each other out – an effect which is called destructive interference .
Latency, from a general point of view, is a time delay between the cause and the effect of some physical change in the system being observed. Lag, as it is known in gaming circles, refers to the latency between the input to a simulation and the visual or auditory response, often occurring because of network delay in online games.
It specifies the latency for a bit of data to travel across the network from one communication endpoint to another. [1] [2]: 5 It is typically measured in multiples or fractions of a second. Delay may differ slightly, depending on the location of the specific pair of communicating endpoints.