Search results
Results from the WOW.Com Content Network
While the carry flag is well-defined for addition, there are two ways in common use to use the carry flag for subtraction operations. The first uses the bit as a borrow flag, setting it if a<b when computing a−b, and a borrow must be performed. If a≥b, the bit is cleared.
The carry, parity, auxiliary carry (or half carry), zero and sign flags are included in many architectures (many modern (RISC) architectures do not have flags, such as carry, and even if they do use flags, then half carry is rare, since BCD math no longer common, and it even has limited support on long mode on x86-64).
The Auxiliary Carry flag is set (to 1) if during an "add" operation there is a carry from the low nibble (lowest four bits) to the high nibble (upper four bits), or a borrow from the high nibble to the low nibble, in the low-order 8-bit portion, during a subtraction. Otherwise, if no such carry or borrow occurs, the flag is cleared or "reset ...
A status register, flag register, or condition code register (CCR) is a collection of status flag bits for a processor.Examples of such registers include FLAGS register in the x86 architecture, flags in the program status word (PSW) register in the IBM System/360 architecture through z/Architecture, and the application program status register (APSR) in the ARM Cortex-A architecture.
Rotate through carry is a variant of the rotate operation, where the bit that is shifted in (on either end) is the old value of the carry flag, and the bit that is shifted out (on the other end) becomes the new value of the carry flag. A single rotate through carry can simulate a logical or arithmetic shift of one position by setting up the ...
V Overflow flag. Set in case of two's complement overflow. S Sign flag. Unique to AVR, this is always N⊕V, and shows the true sign of a comparison. H Half-carry flag. This is an internal carry from additions and is used to support BCD arithmetic. T Bit copy. Special bit load and bit store instructions use this bit. I Interrupt flag. Set when ...
Most computers have two dedicated processor flags to check for overflow conditions. The carry flag is set when the result of an addition or subtraction, considering the operands and result as unsigned numbers, does not fit in the given number of bits. This indicates an overflow with a carry or borrow from the most significant bit.
the carry flag uses a "borrow bit" convention for subtracts, rather than the "carry bit" convention used by Microchip; they also include a signed overflow flag, which like the digit carry, is set by add, subtract and compare instructions (every instruction which sets the carry flag except for shift instructions);