enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Disc cutter - Wikipedia

   en.wikipedia.org/wiki/Disc_cutter

   For long straight cuts on sheet metal or for light cut-off work, a standard circular saw is used with a 7 + 1 ⁄ 4-inch cutting wheel. These cutting discs are made just like the smaller wheels of an angle grinder, with resin bonded abrasive material, or are of metal with a diamond-coated edge.

3. Grinding wheel - Wikipedia

   en.wikipedia.org/wiki/Grinding_wheel

   The wheel type (e.g. cup or plain wheel below) fit freely on their supporting arbors, the necessary clamping force to transfer the rotary motion being applied to the wheels side by identically sized flanges (metal discs). The paper blotter shown in the images is intended to distribute this clamping force evenly across the wheels surface.

4. Grinding (abrasive cutting) - Wikipedia

   en.wikipedia.org/wiki/Grinding_(abrasive_cutting)

   A man grinding on metal using an angle grinder, causing a lot of sparks. Grinding is a type of abrasive machining process which uses a grinding wheel as cutting tool. A wide variety of machines are used for grinding, best classified as portable or stationary: Portable power tools such as angle grinders, die grinders and cut-off saws

5. Circular saw - Wikipedia

   en.wikipedia.org/wiki/Circular_saw

   Circular saw with a diamond blade for cutting asphalt and concrete. The rotary motion of a circular saw lends itself to cutting hard materials like concrete, asphalt, metal, tile, brick, and stone with an abrasive saw such as a tile saw. Diamond blades and cut off wheels are commonly used in these applications.

6. Abrasive saw - Wikipedia

   en.wikipedia.org/wiki/Abrasive_saw

   Steel cut-off saw for workshop use Cutting heavy steel cable with a Husqvarna freehand saw US Navy diver preparing to use an abrasive saw for underwater salvage. An abrasive saw, also known as a cut-off saw or chop saw, is a circular saw (a kind of power tool) which is typically used to cut hard materials, such as metals, tile, and concrete.

7. Roll forming - Wikipedia

   en.wikipedia.org/wiki/Roll_forming

   It typically begins with a large coil of sheet metal, between 1 inch (2.5 cm) and 20 inches (51 cm) in width, and 0.004 inches (0.10 mm) and 0.125 inches (3.2 mm) thick, supported on an uncoiler. The strip is fed through an entry guide to properly align the material as it passes through the rolls of the mill, each set of rolls forming a bend ...