Ad
related to: how to test psu power
Search results
Results from the WOW.Com Content Network
You can check the power supply on your PC by removing the side panel of its case, or by checking the manual that came with it. How to check the power supply on your PC, a crucial step before ...
The ATX specification defines the Power-Good signal as a +5-volt (V) signal generated in the power supply when it has passed its internal self-tests and the outputs have stabilized. This normally takes between 0.1 and 0.5 seconds after the power supply is switched on.
Entry-Level Power Supply Specification (EPS) is a power supply unit meant for high-power-consumption computers and entry-level servers. Developed by the Server System Infrastructure (SSI) forum, a group of companies including Intel, Dell, Hewlett-Packard and others, that works on server standards, the EPS form factor is a derivative of the ATX ...
A power-on self-test (POST) is a process performed by firmware or software routines immediately after a computer or other digital electronic device is powered on. [ 1 ] POST processes may set the initial state of the device from firmware and detect if any hardware components are non-functional.
A heavily loaded power supply and the computer it is powering generate significant amounts of heat, which may raise the power supply temperature, which is likely to decrease its efficiency. Since power supplies are certified at room temperature, this effect is not taken into account. [5] [15] 80 Plus does not set efficiency targets for very low ...
Load regulation is the capability to maintain a constant voltage (or current) level on the output channel of a power supply despite changes in the supply's load (such as a change in resistance value connected across the supply output). [1] [2]
PS-ON Signal is a pin on a 20-pin or 24-pin ATX-specified power connector used to turn a personal computer power supply unit on/off. The PS_ON pin is normally pulled high in an open-circuit, but will turn on the power supply when it is pulled low, by shorting it to the common signal (COM).
Also, increasing circuit size means a single fault will have a lower percentage effect, making it harder for the test to detect. However, Iddq is so useful that designers are taking steps to keep it working. One particular technique that helps is power gating, where the entire power supply to each block can be switched off using a low leakage ...
Ad
related to: how to test psu power